1991 1996 Toyota Camry Headlight Replacement 1991 1992 1993 1994 1995 1996 Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 15 minutes

Sections

Headlight
4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Back1991-1996 Toyota Camry
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Headlight

To lift the hood of the car, pull the latch with the “hood up” icon up towards you. This latch can be found below the steering wheel and sits directly above where your left foot rests.
After lifting the hood of the car, click the latch (located just above the Toyota logo visible on the front bumper) holding the hood down upward. Lift the hood upward.

To lift the hood of the car, pull the latch with the “hood up” icon up towards you. This latch can be found below the steering wheel and sits directly above where your left foot rests.

After lifting the hood of the car, click the latch (located just above the Toyota logo visible on the front bumper) holding the hood down upward. Lift the hood upward.

1024

Step 2

Locate the headlight bulb plug (right side headlight plug shown). This can be found underneath the hood and is positioned directly behind the headlight.

Locate the headlight bulb plug (right side headlight plug shown). This can be found underneath the hood and is positioned directly behind the headlight.

Step 3

Once you’ve found the headlight bulb plug (left side shown), twist the plug out of its locked position by rotating it counter clockwise (as seen in the video).
Pull the plug toward you to completely remove it.

Once you’ve found the headlight bulb plug (left side shown), twist the plug out of its locked position by rotating it counter clockwise (as seen in the video).

Pull the plug toward you to completely remove it.

Step 4

On the backside of the bulb socket, click the release lever down (as seen in the video). This will allow you to remove and replace the bulb
Pull the old bulb end (which rests just above the previously mentioned release level) up to remove it
Push new bulb end down until it clicks into position
Do not touch the glass of the new bulb with your hands during installation. Oils from your fingers can overheat the glass and cause premature failure .

On the backside of the bulb socket, click the release lever down (as seen in the video). This will allow you to remove and replace the bulb

Pull the old bulb end (which rests just above the previously mentioned release level) up to remove it

Push new bulb end down until it clicks into position

Do not touch the glass of the new bulb with your hands during installation. Oils from your fingers can overheat the glass and cause premature failure .

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      7 other people completed this guide.

Author

                                      with 2 other contributors

                    Matt Bowman

Member since: 10/24/2015

167 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       PIRL Gadget Garage                        

                                                  Member of PIRL Gadget Garage 



                    Community                     


                                            9 Members                     


                                            10 Guides authored

Member-Contributed Guide#

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Member-Contributed Guide

Introduction

What you need

Team