Difficulty

Moderate

Steps

11

Time Required

                          30 minutes - 1 hour

Sections

1

  • Headlights
  • 11 steps

Flags

3

Confusing Text

Some of this guide’s text is confusing, duplicated, or off-topic. Clarify it by editing!

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • Back1994-2004 Ford Mustang

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Prior to beginning your guide, make sure that your car is off and the emergency break is on.

What you need

Step 1

              Headlights
  • To open the hood, pull the release lever by your foot break inside the car.

To open the hood, pull the release lever by your foot break inside the car.

1024

Step 2

  • To raise the hood, lift up on handle at the front of the hood.

To raise the hood, lift up on handle at the front of the hood.

Step 3

  • Remove this cover.

Remove this cover.

Step 4

  • Using the 11mm wrench remove the nut.

Using the 11mm wrench remove the nut.

Step 5

  • Gently pull out the side paneling using your hands

Gently pull out the side paneling using your hands

Step 6

  • Take out the turn signal light by twisting it and remove the side panel.

Take out the turn signal light by twisting it and remove the side panel.

Step 7

  • Remove the bulb from the connector by pulling the two apart and connect the new bulb.

Remove the bulb from the connector by pulling the two apart and connect the new bulb.

Step 8

  • In the same area where you removed the screw, remove the clip by hand or use needle nose pliers.

In the same area where you removed the screw, remove the clip by hand or use needle nose pliers.

Step 9

  • Identify the three retainers. Two of them are on the same side from which the metal clip was removed. The other is on the opposite side. The third one is shown in the next step.
  • Slide the 12mm wrench over the retainer and push until you are able to remove the headlight.

Identify the three retainers. Two of them are on the same side from which the metal clip was removed. The other is on the opposite side. The third one is shown in the next step.

Slide the 12mm wrench over the retainer and push until you are able to remove the headlight.

Step 10

  • Third retainer. To push the retainers in so that I was able to remove the headlight I pressed the handle of the wrench against the metal part of the retainers and pushed.

Third retainer. To push the retainers in so that I was able to remove the headlight I pressed the handle of the wrench against the metal part of the retainers and pushed.

Step 11

  • Similar to removing the turn signal, twist the headlight connector and remove the headlight from the bulb.
  • Disconnect the bulb from the connector by pulling the two apart and connect the new bulb. Attach the new bulb to the connector.

Similar to removing the turn signal, twist the headlight connector and remove the headlight from the bulb.

Disconnect the bulb from the connector by pulling the two apart and connect the new bulb. Attach the new bulb to the connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Josiah Crutchfield

Member since: 03/21/2021

265 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       University of Memphis, Team S52-G3, Kim Spring 2021                        

                                                  Member of University of Memphis, Team S52-G3, Kim Spring 2021 



                    UM-KIM-S21S52G3                     


                                            1 Member                     


                                            1 Guide authored