Difficulty
Moderate
Steps
5
Time Required
30 minutes
Sections
1
- Ignition Coils
- 5 steps
Flags
0
Back1999-2006 BMW 3 Series
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Ignition Coils
- Release the hood latch by pulling the lever found in the driver foot well.
- Open the hood.
Release the hood latch by pulling the lever found in the driver foot well.
Open the hood.
1024
Step 2
- Remove the oil cap and note the four bolt placements.
Remove the oil cap and note the four bolt placements.
Step 3
- Using a 10 mm socket wrench, remove the four bolts holding down the engine covers.
Using a 10 mm socket wrench, remove the four bolts holding down the engine covers.
Step 4
- Note the placement of each ignition coil then remove the plastic latch and disconnect each cable.
Note the placement of each ignition coil then remove the plastic latch and disconnect each cable.
Step 5
- With a firm grip, remove each ignition coil and replace with the new coils respectively.
- Repeat steps 4 to 1 for reassembly.
With a firm grip, remove each ignition coil and replace with the new coils respectively.
Repeat steps 4 to 1 for reassembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 3 other contributors
Osama Almasri
Member since: 10/14/2020
193 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
University of Memphis, Team S2-G5, Willis Fall 2020
Member of University of Memphis, Team S2-G5, Willis Fall 2020
UM-WILLIS-F20S2G5
1 Member
1 Guide authored
