Difficulty

Easy

Steps

5

Time Required

                          10 minutes

Sections

1

  • A/C Filter
  • 5 steps

Flags

2

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • Back2005-2009 Subaru Outback

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove the right dashboard panel
  • Remove all contents in the glove box.
  • Gently pry and pull out the dashboard panel located at the right side of the glove box.

Remove all contents in the glove box.

Gently pry and pull out the dashboard panel located at the right side of the glove box.

1024

Step 2

              Remove the glove box
  • Unscrew the screw that holds the pin on the right hinge of the glove box.
  • Disconnect the damper (string) locate on the right side of the glove box.
  • Push in the sides of the glove box to release the knock pins.
  • Remove the glove box by disengaging the left hinge.

Unscrew the screw that holds the pin on the right hinge of the glove box.

Disconnect the damper (string) locate on the right side of the glove box.

Push in the sides of the glove box to release the knock pins.

Remove the glove box by disengaging the left hinge.

Step 3

              Remove the upper storage box
  • Remove the 3 screws on the left side of the upper storage box.
  • Pull out the upper storage box.

Remove the 3 screws on the left side of the upper storage box.

Pull out the upper storage box.

Step 4

              Remove bracket
  • Remove the screws to take out the bracket from hole where the storage box was removed.
  • Peel off Velcro tape attaching the insulator, and push up the insulator.

Remove the screws to take out the bracket from hole where the storage box was removed.

Peel off Velcro tape attaching the insulator, and push up the insulator.

Step 5

              Remove & replace filter
  • Press inward the four tabs on the filter housing and the filter tray out. You need to slide the tray below the upper storage support.
  • Replace the filter. The air flow arrow on the filter must point down.

Press inward the four tabs on the filter housing and the filter tray out. You need to slide the tray below the upper storage support.

Replace the filter. The air flow arrow on the filter must point down.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Attached Documents

  • 29 A C Filter
  • PDF - 80.00 kb
  • View

29 A C Filter

PDF - 80.00 kb

Author

                                      with 2 other contributors 


                    Emme

Member since: 06/15/2017

473 Reputation

                                      3 Guides authored                  



                       Badges:
                       7





                                                        +4 more badges