2010 2017 Suzuki Swift Engine Air Filter Replacement 2010 2011 2012 2013 2014 2015 2016 2017 Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          5 minutes            

Sections

1

• Engine Air Filter
• 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• Back2010-2017 Suzuki Swift

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Depending on your preferences, there are many types of replacement filters available. Make sure it will fit the vehicle.

What you need

Step 1

              locate the filter               

• The filter housing is located behind the air intake.
• Pull both clasps holding the filter housing to the air intake.
• Push the housing back to see the filter.

The filter housing is located behind the air intake.

Pull both clasps holding the filter housing to the air intake.

Push the housing back to see the filter.

1024

Step 2

              remove old filter               

• Slide the old filter up and out.
• Remember the only square corner of the filter is in the left bottom side.
• Clean the immediate area of the filter housing, to make sure no dirt ends up in the engine.

Slide the old filter up and out.

Remember the only square corner of the filter is in the left bottom side.

Clean the immediate area of the filter housing, to make sure no dirt ends up in the engine.

Step 3

              add new filter               

• With the square corner at the correct position, slide the new filter in.
• Make sure the filter fits up with the backside of the air intake on all sides.

With the square corner at the correct position, slide the new filter in.

Make sure the filter fits up with the backside of the air intake on all sides.

Step 4

              close the filter housing               

• Underneath the air filter, 2 holes have to line up with plugs on the filter housing.
• Once the underside is connected correctly, a small plastic protrustion has to line up with a corresponding guide on the air intake.
• Clip back the 2 clips, and you are done.

Underneath the air filter, 2 holes have to line up with plugs on the filter housing.

Once the underside is connected correctly, a small plastic protrustion has to line up with a corresponding guide on the air intake.

Clip back the 2 clips, and you are done.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    knipwim                     

Member since: 09/01/2018

7,452 Reputation

                                      29 Guides authored                  



                       Badges:
                       37







                                                        +34 more badges                           

burakkurhan - Jun 9, 2020

Reply

Thanks a lot