Difficulty
Easy
Steps
7
Time Required
10 minutes
Sections
1
- Tail Light and Bulbs
- 7 steps
Flags
0
BackFord F-Series
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Tail Light and Bulbs
- Locate the two 8 mm screws that attach the taillight housing to the vehicle.
Locate the two 8 mm screws that attach the taillight housing to the vehicle.
1024
Step 2
- Using a socket and ratchet wrench, remove the two screws facing the inside of the bed that you located in Step 1.
Using a socket and ratchet wrench, remove the two screws facing the inside of the bed that you located in Step 1.
Step 3
- Pull the light housing outward at an angle away from the truck.
Pull the light housing outward at an angle away from the truck.
Step 4
- Twist the light socket in a counterclockwise motion to remove the bulbs.
Twist the light socket in a counterclockwise motion to remove the bulbs.
Step 5
- Insert a new bulb.
- Place the light bulb socket back in the hole and turn clockwise until it’s locked in place.
Insert a new bulb.
Place the light bulb socket back in the hole and turn clockwise until it’s locked in place.
Step 6
- Line up the taillight housing with the holes and guides, and push it into place.
Line up the taillight housing with the holes and guides, and push it into place.
Step 7
- Use a socket and ratchet wrench to tighten the screws back into the taillight housing.
Use a socket and ratchet wrench to tighten the screws back into the taillight housing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Russell Wainwright
Member since: 09/20/2020
145 Reputation
1 Guide authored
Badges:
2
Team
University of Memphis, Team S1-G17, Bishop Fall 2020
Member of University of Memphis, Team S1-G17, Bishop Fall 2020
UM-BISHOP-F20S1G17
1 Member
1 Guide authored