2011 2017 Hyundai Veloster Back Up Light And Brake Light Replacement 2011 2012 2013 2014 2015 2016 2017 Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes - 1 hour

Sections

Back-Up Light and Brake Light
6 steps

Flags

BackHyundai
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Are the back-up or brake lights not working in your Hyundai Veloster? Don’t want to spend money on the replacement to the auto store? Save money and do it yourself at home or in your garage following this guide step by step. It is easy to understand and follow even you are a beginner.

In this guide, I will replace the back-up light and brake light for a 2012 Hyundai Veloster.

———————————————————————————————————————————————

Brake and tail light bulb type: P28/8W (Wattage: 28/8 )

Back-up light bulb type: W16W (Wattage: 16)

Note: You can wear your safety & work gloves before working on the replacement.

What you need

Step 1

              Back-Up Light and Brake Light

Make sure the car is off before you start your replacement. However, You don’t have to disconnect the car battery.
Open the trunk first.
Using Phillips #2 screwdriver, remove the two 10 mm screws from the back & tail light.

Make sure the car is off before you start your replacement. However, You don’t have to disconnect the car battery.

Open the trunk first.

Using Phillips #2 screwdriver, remove the two 10 mm screws from the back & tail light.

1024

Step 2

Using both hands, carefully pull the brake & tail light off.

Using both hands, carefully pull the brake & tail light off.

Step 3

Here is the tail light assembly.
The left one is for the brake light.
The right one is for the back-up light.

Here is the tail light assembly.

The left one is for the brake light.

The right one is for the back-up light.

Step 4

Twist and turn the backup light to the right. And then pull it out.
Make sure not to touch the surface of the light bulb because it will break the light bulb easily.

Twist and turn the backup light to the right. And then pull it out.

Make sure not to touch the surface of the light bulb because it will break the light bulb easily.

Step 5

Twist and turn the brake light to the right and pull it out.
Make sure not to touch the surface of the light bulb because it will break the bulb easily.

Twist and turn the brake light to the right and pull it out.

Make sure not to touch the surface of the light bulb because it will break the bulb easily.

Step 6

Replace the light bulbs.
Check that the light bulbs work first before replacing 10 mm screws.

Replace the light bulbs.

Check that the light bulbs work first before replacing 10 mm screws.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor

                    Adrian Ng

Member since: 09/18/2021

196 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       York University, Team E-20, Melo-Thaiss Fall 2021                        

                                                  Member of York University, Team E-20, Melo-Thaiss Fall 2021 



                    YORK-MELO-THAISS-F21SEG20                     


                                            1 Member                     


                                            1 Guide authored

Introduction#

What you need#

Team#

Introduction

What you need

Team