Difficulty

Moderate

Steps

5

Time Required

                          15 minutes

Sections

1

  • Hood
  • 5 steps

Flags

0

  • Back2008-2012 Jeep Liberty

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Hood
  • Open the hood of the Jeep by pulling the hood latch. This is placed right next to the driver’s seat and to the left of the brake pedal.

Open the hood of the Jeep by pulling the hood latch. This is placed right next to the driver’s seat and to the left of the brake pedal.

1024

Step 2

  • Notice a latch located above the car’s grill after popping the hood. Lift the hood by releasing the latch. After lifting the hood, notice a movable latch just above the wiper fluid container. There is a specific hole on the left side of the hood where you can hook the latch.

Notice a latch located above the car’s grill after popping the hood. Lift the hood by releasing the latch. After lifting the hood, notice a movable latch just above the wiper fluid container. There is a specific hole on the left side of the hood where you can hook the latch.

Step 3

  • Disconnect the wind-shield fluid line on the left side of the hood.

Disconnect the wind-shield fluid line on the left side of the hood.

Step 4

  • Identify the four bolts which can be seen towards the extreme left (2 bolts) and extreme right (2 bolts) underneath the hood.

Identify the four bolts which can be seen towards the extreme left (2 bolts) and extreme right (2 bolts) underneath the hood.

Step 5

  • Remove the four bolts using a 13mm wrench and lift the hood out of place.
  • After replacing the old hood with the new hood, reverse the process; tighten back the four bolts and connect the wind-shield fluid line.

Remove the four bolts using a 13mm wrench and lift the hood out of place.

After replacing the old hood with the new hood, reverse the process; tighten back the four bolts and connect the wind-shield fluid line.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Daniel Strode

Member since: 03/23/2021

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       UMass Dartmouth, Team S1-G20, Sinclaire Spring 2021                        

                                                  Member of UMass Dartmouth, Team S1-G20, Sinclaire Spring 2021 



                    UMASSD-SINCLAIRE-S21S1G20                     


                                            2 Members                     


                                            1 Guide authored