Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes

Sections

1

  • Engine Air Filter
  • 6 steps

Flags

0

  • Back2013-2016 Scion FRS (Toyota gt86)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Engine Air Filter
  • Pull the handle located near the driver’s left leg to unlock the hood.
  • Pull the secondary latch located to the right of the emblem.
  • Prop up the hood.
  • Make sure you’re not working in a high wind area, as that might blow the hood backward and damage your vehicle.

Pull the handle located near the driver’s left leg to unlock the hood.

Pull the secondary latch located to the right of the emblem.

Prop up the hood.

Make sure you’re not working in a high wind area, as that might blow the hood backward and damage your vehicle.

1024

Step 2

  • Locate the air filter box, which can be found to the front right of the car.

Locate the air filter box, which can be found to the front right of the car.

Step 3

  • Pull the metal clips up from the top. They will pop out.

Pull the metal clips up from the top. They will pop out.

Step 4

  • Grab the back of the box and pull it towards the top.
  • To pull out the air-filter, simply pull it away from the car and lift up.

Grab the back of the box and pull it towards the top.

To pull out the air-filter, simply pull it away from the car and lift up.

Step 5

  • Repeat the process in reverse to install the air filter.
  • Make sure that the tabs on the filter are on the bottom.

Repeat the process in reverse to install the air filter.

Make sure that the tabs on the filter are on the bottom.

Step 6

  • Line up the little pins on the cover of the box with the base of the box in order to close it.
  • Clip the pins back in and you’re done!

Line up the little pins on the cover of the box with the base of the box in order to close it.

Clip the pins back in and you’re done!

Now that the new filter is installed, you’re good to go.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Mark Symonenko

Member since: 09/25/2018

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Eastern Washington University, Team S3-G2, Crane Fall 2018                        

                                                  Member of Eastern Washington University, Team S3-G2, Crane Fall 2018 



                    EWU-CRANE-F18S3G2                     


                                            3 Members                     


                                            8 Guides authored