Difficulty
Moderate
Steps
5
Time Required
45 minutes - 2 hours
Sections
1
- Oil and Oil Filter
- 5 steps
Flags
3
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Better Introduction
Improve this guide by completing or revising its introduction.
BackHonda Motorcycle
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Oil and Oil Filter
- Open the oil reservoir cap, located on the right side of the bike just behind the foot peg.
Open the oil reservoir cap, located on the right side of the bike just behind the foot peg.
1024
Step 2
- Using a ratchet and socket, loosen the bolt.
Using a ratchet and socket, loosen the bolt.
Step 3
- Once the bolt is removed the oil will drain out. Let all of the oil drain into the oil pan.
- The drip should be as pictured before screwing the bolt back in.
Once the bolt is removed the oil will drain out. Let all of the oil drain into the oil pan.
The drip should be as pictured before screwing the bolt back in.
Step 4
- Once the bolt is tightly secured back in, unscrew the oil filter.
- The oil filter is located on the underside of the bike but near the front wheel. If the filter is too tight, use channel lock pliers to get it off.
Once the bolt is tightly secured back in, unscrew the oil filter.
The oil filter is located on the underside of the bike but near the front wheel. If the filter is too tight, use channel lock pliers to get it off.
Step 5
- Once the new oil filter is installed, return to the oil reservoir mentioned in step 1. Insert a funnel and begin pouring in new oil, the type of oil required is SAE 10W-30.
- If you change the oil filter 3.6 quarts will be needed. If you didn’t replace the oil filter only 3.3 quarts will be needed.
Once the new oil filter is installed, return to the oil reservoir mentioned in step 1. Insert a funnel and begin pouring in new oil, the type of oil required is SAE 10W-30.
If you change the oil filter 3.6 quarts will be needed. If you didn’t replace the oil filter only 3.3 quarts will be needed.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Timothy Riggs
Member since: 03/04/2021
121 Reputation
1 Guide authored
Badges:
2
Team
University of Memphis, Team S51-G5, Willis Spring 2021
Member of University of Memphis, Team S51-G5, Willis Spring 2021
UM-WILLIS-S21S51G5
1 Member
1 Guide authored
