Difficulty
Easy
Steps
6
Time Required
9 - 20 minutes
Sections
1
- Dome light
- 6 steps
Flags
0
BackNissan
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Dome light
- Remove the plastic covering for the interior dome light. using your hands or an opening tool.
- There are clips securing the cover so be sure to undo them as you remove the cover.
- Because of the delicacy of the covering, it is recommended that you use your hands, however even with your hands proceed with caution as to not break the lid and/or clips.
Remove the plastic covering for the interior dome light. using your hands or an opening tool.
There are clips securing the cover so be sure to undo them as you remove the cover.
Because of the delicacy of the covering, it is recommended that you use your hands, however even with your hands proceed with caution as to not break the lid and/or clips.
1024
Step 2
- Make sure the light bulb isn’t hot before taking it out.
- If it’s still hot, wait about 30 seconds to a minute and the bulb should cool down enough to take it out.
Make sure the light bulb isn’t hot before taking it out.
If it’s still hot, wait about 30 seconds to a minute and the bulb should cool down enough to take it out.
Step 3
- Remove the light by pulling out the bulb from the socket.
- If you are having trouble pulling out the lightbulb, try lightly wiggling the bulb until it is loose enough to pull out.
Remove the light by pulling out the bulb from the socket.
If you are having trouble pulling out the lightbulb, try lightly wiggling the bulb until it is loose enough to pull out.
Step 4
- Replace the dead or broken bulb with a new bulb and insert it into the socket.
- The socket for a Nissan Micra is a W5W bulb.
- When replacing the bulb, make sure you have the power switch off so you don’t burn yourself.
- The light bulb is delicate so when putting the bulb into the socket to not apply too much force or else you may break the bulb.
Replace the dead or broken bulb with a new bulb and insert it into the socket.
The socket for a Nissan Micra is a W5W bulb.
When replacing the bulb, make sure you have the power switch off so you don’t burn yourself.
The light bulb is delicate so when putting the bulb into the socket to not apply too much force or else you may break the bulb.
Step 5
- Turn on the light by pressing the switch to make sure the bulb and socket works.
- If it does work then your light should be shining similar to the photos shown.
Turn on the light by pressing the switch to make sure the bulb and socket works.
If it does work then your light should be shining similar to the photos shown.
Step 6
- Place the covering for the light back into place.
- There are six holes on the light assembly and each of them connects to a specific clip of the lid.
- Use your fingers to press the lid into place and you are done, You now have a new light that’ll light up your car.
Place the covering for the light back into place.
There are six holes on the light assembly and each of them connects to a specific clip of the lid.
Use your fingers to press the lid into place and you are done, You now have a new light that’ll light up your car.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Sanjeev Visvalingam
Member since: 09/06/2021
133 Reputation
1 Guide authored
Badges:
2
Team
York University, Team 1-27, O'Regan Fall 2021
Member of York University, Team 1-27, O'Regan Fall 2021
YORK-O'REGAN-F21S1G27
1 Member
1 Guide authored
