Difficulty
Easy
Steps
6
Time Required
10 - 15 minutes
Sections
1
- Rear Signal Light Bulb
- 6 steps
Flags
0
BackHonda
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Rear turn signal lights are light bulbs that communicate the driver’s intent to change lanes, so it is essential to change these lightbulbs if they stop functioning. The specific rear turn signal light bulb necessary for this vehicle model is 21 W (Amber).
This guide will show you how to replace the left rear signal light bulb, but the process is the same on both the left and right rear signal light bulbs.
Before starting, make sure that you turn off your vehicle and engage the parking brake.
What you need
Step 1
Rear Signal Light Bulb
- Press the tailgate release button and lift open the rear hatch.
Press the tailgate release button and lift open the rear hatch.
1024
Step 2
- Remove the two screws beside each tail light assembly (four total) using a Phillips #1 screwdriver.
Remove the two screws beside each tail light assembly (four total) using a Phillips #1 screwdriver.
Step 3
- Place both hands on the tail light assembly and pull it directly outwards (away from the vehicle).
- The tail light assembly will still be connected to the vehicle by wiring, so make sure to be careful when pulling the light assembly out.
Place both hands on the tail light assembly and pull it directly outwards (away from the vehicle).
The tail light assembly will still be connected to the vehicle by wiring, so make sure to be careful when pulling the light assembly out.
Step 4
- Remove the rear signal light bulb from the light assembly by rotating the bulb socket counterclockwise.
Remove the rear signal light bulb from the light assembly by rotating the bulb socket counterclockwise.
Step 5
- Pull apart the light bulb from its socket.
- Replace with a new light bulb and apply pressure to ensure the light bulb is securely fastened.
Pull apart the light bulb from its socket.
Replace with a new light bulb and apply pressure to ensure the light bulb is securely fastened.
Step 6
- Slide the light assembly into the raised white plastic attached to the vehicle.
- Align the holes on the light assembly to the holes on the vehicle and fasten the bolts into position.
Slide the light assembly into the raised white plastic attached to the vehicle.
Align the holes on the light assembly to the holes on the vehicle and fasten the bolts into position.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Guadalupe Guevara
Member since: 10/26/2022
133 Reputation
1 Guide authored
Badges:
2
Team
CSU Los Angeles, Team 2-8, Briggs Fall 2022
Member of CSU Los Angeles, Team 2-8, Briggs Fall 2022
CSULA-BRIGGS-F22S2G8
1 Member
1 Guide authored
