Difficulty
Moderate
Steps
3
Time Required
7 - 10 minutes
Sections
1
- Bottom Shell
- 3 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
Back3DR Iris Plus
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Bottom Shell
- Remove the eight 11mm screws attaching the underbody of the drone using the 2mm Hex screwdriver/key.
Remove the eight 11mm screws attaching the underbody of the drone using the 2mm Hex screwdriver/key.
1024
Step 2
- Remove the two larger, 12mm screws attached to the Go Pro mount using the 3mm Hex screwdriver/key.
- Lift to remove the mount.
Remove the two larger, 12mm screws attached to the Go Pro mount using the 3mm Hex screwdriver/key.
Lift to remove the mount.
Step 3
- Feed both wires through the grill of the bottom shell.
- Lift to remove the shell.
- There are two cables tethering the shell to the body of the drone. It is difficult and unnecessary to remove them. Simply lay the shell to the side.
Feed both wires through the grill of the bottom shell.
Lift to remove the shell.
There are two cables tethering the shell to the body of the drone. It is difficult and unnecessary to remove them. Simply lay the shell to the side.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Evan Witulski
Member since: 02/10/2020
349 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S7-G5, Regan Winter 2020
Member of Cal Poly, Team S7-G5, Regan Winter 2020
CPSU-REGAN-W20S7G5
5 Members
9 Guides authored
