Difficulty
Moderate
Steps
9
Time Required
3 - 5 minutes
Sections
2
- Battery
- 3 steps
- Keyboard
- 6 steps
Flags
0
BackAcer Aspire 3000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Begin with the device face down.
- Orient the laptop so that the battery is on the side opposite of you and the headphone ports are facing towards you.
Begin with the device face down.
Orient the laptop so that the battery is on the side opposite of you and the headphone ports are facing towards you.
1024
Step 2
- Slide the button found below the battery to the left into the unlocked position.
- You will know the battery is unlocked if the tab is pushed to the side where the symbol is unlocked.
Slide the button found below the battery to the left into the unlocked position.
You will know the battery is unlocked if the tab is pushed to the side where the symbol is unlocked.
Step 3
- Locate the battery and the tab to the right of it.
- Pull the tab to the right while simultaneously pushing the battery away from you.
- Make sure you push the battery only when tab is held in the right position in order to avoid damage to the device.
Locate the battery and the tab to the right of it.
Pull the tab to the right while simultaneously pushing the battery away from you.
Make sure you push the battery only when tab is held in the right position in order to avoid damage to the device.
Step 4
Keyboard
- Lift the laptop to be on its edge, with the bottom of the screen in the air.
Lift the laptop to be on its edge, with the bottom of the screen in the air.
Step 5
- Remove the three 4.6 mm Phillips #1 screws that are on this edge.
Remove the three 4.6 mm Phillips #1 screws that are on this edge.
Step 6
- Wedge a spudger into the latch on the right side.
- Open the lid completely to facilitate removal.
- Pull the handle of the spudger towards you to pop the first of the tabs that hold this piece in place.
- Starting from right to left, pop the remaining tabs by lifting up on the panel and rotating the panel to the left.
Wedge a spudger into the latch on the right side.
Open the lid completely to facilitate removal.
Pull the handle of the spudger towards you to pop the first of the tabs that hold this piece in place.
Starting from right to left, pop the remaining tabs by lifting up on the panel and rotating the panel to the left.
Step 7
- Unscrew the two 4.6 mm Phillips #1 screws.
Unscrew the two 4.6 mm Phillips #1 screws.
Step 8
- Gently lift the top edge of the keyboard out of its place.
- Do not completely remove the keyboard as there is still a ribbon cable connecting it to the device.
Gently lift the top edge of the keyboard out of its place.
Do not completely remove the keyboard as there is still a ribbon cable connecting it to the device.
Step 9
- Lift the ZIF connector’s black retaining flap. Then gently slide the ribbon cable out.
- Remove the keyboard.
Lift the ZIF connector’s black retaining flap. Then gently slide the ribbon cable out.
Remove the keyboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Lykia Harper
Member since: 10/29/2016
258 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Baylor, Team 4-2, Williams Fall 2016
Member of Baylor, Team 4-2, Williams Fall 2016
BU-WILLIAMS-F16S4G2
4 Members
7 Guides authored
