Difficulty

Moderate

Steps

8

Time Required

                          25 minutes

Sections

1

  • Fan
  • 8 steps

Flags

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

  • BackAcer Aspire 4810TZ-4120

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Fan
  • Lay the acer upside down
  • Use your screwdriver to unscrew all 19 two 5mm Phillips screws from the case
  • After unscrewing all the screws, lift the case upwards and remove it

Lay the acer upside down

Use your screwdriver to unscrew all 19 two 5mm Phillips screws from the case

After unscrewing all the screws, lift the case upwards and remove it

1024

Step 2

  • Go on the side of the computer
  • Use the plastic opening tool and press it in between the upper case and lover case
  • When the plastic tool is in between the cases, start going around the computer until both case are officially not connected

Go on the side of the computer

Use the plastic opening tool and press it in between the upper case and lover case

When the plastic tool is in between the cases, start going around the computer until both case are officially not connected

Step 3

  • Get a pair of tweezers
  • Start to detach the wires that are connected to the computer
  • Get a screwdriver and unscrew the screws that are circled in the picture

Get a pair of tweezers

Start to detach the wires that are connected to the computer

Get a screwdriver and unscrew the screws that are circled in the picture

Step 4

  • Repeat Step 3 for detaching the rest of the tape
  • Disconnect all wires from the boards

Repeat Step 3 for detaching the rest of the tape

Disconnect all wires from the boards

Step 5

  • Lift up the upper case
  • Disconnect the power supply wiring (the black wire)

Lift up the upper case

Disconnect the power supply wiring (the black wire)

Step 6

  • Remove the three screws
  • Pull the boards upward
  • Flip the boards upside down
  • The screws and the board were removed so that the holes could be better shown

Remove the three screws

Pull the boards upward

Flip the boards upside down

The screws and the board were removed so that the holes could be better shown

Step 7

  • Remove the four (4) screws that are holding the CPU’s cover on

Remove the four (4) screws that are holding the CPU’s cover on

Step 8

  • Gently detached the wire that is connected to the computer

Gently detached the wire that is connected to the computer

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Maria Saavedra

Member since: 09/20/2017

257 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       University of North Texas, Team S5-G3, Thomas Fall 2017                        

                                                  Member of University of North Texas, Team S5-G3, Thomas Fall 2017 



                    UNT-THOMAS-F17S5G3                     


                                            4 Members                     


                                            5 Guides authored