Difficulty
Moderate
Steps
9
Time Required
8 minutes
Sections
2
- Battery
- 4 steps
- Power Board
- 5 steps
Flags
0
BackAcer Aspire 6530-6522
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Make sure the device is unplugged and completely powered down.
- Turn the device over.
Make sure the device is unplugged and completely powered down.
Turn the device over.
1024
Step 2
- The lock switch can slide either towards or away from the battery. If it is pushed towards the battery, the release switch is locked and the battery can not be released.
- Slide the switch away from the battery.
The lock switch can slide either towards or away from the battery. If it is pushed towards the battery, the release switch is locked and the battery can not be released.
Slide the switch away from the battery.
Step 3
- The battery release switch is just to the inside of the battery and slides parallel to it.
- Push the switch to the side. It is not just an open or close switch, it actually pops the battery up so you will feel some resistance.
- When inserting a battery back into the device, you do not need to touch this switch. Just press the battery firmly down, you will see and hear this switch catch.
The battery release switch is just to the inside of the battery and slides parallel to it.
Push the switch to the side. It is not just an open or close switch, it actually pops the battery up so you will feel some resistance.
When inserting a battery back into the device, you do not need to touch this switch. Just press the battery firmly down, you will see and hear this switch catch.
Step 4
- Pull the battery up and out. Use a plastic opening tool if necessary.
Pull the battery up and out. Use a plastic opening tool if necessary.
Step 5
Power Board
- Using the Phillips #1 screwdriver, remove the ten 7mm screws in the bottom of the device that are holding the top panel.
- Turn the device over and open it.
Using the Phillips #1 screwdriver, remove the ten 7mm screws in the bottom of the device that are holding the top panel.
Turn the device over and open it.
Step 6
- Lift the top panel up from the back, turning it over forward.
Lift the top panel up from the back, turning it over forward.
Step 7
- Lift the latch locking the cable.
- Pull the cable free.
Lift the latch locking the cable.
Pull the cable free.
Step 8
- Pull the cable towards you to unplug it. Use tweezers if necessary.
Pull the cable towards you to unplug it. Use tweezers if necessary.
Step 9
- Using the Phillips #1 screwdriver, remove the three 3mm screws from the power board.
- Lift power board to remove it.
Using the Phillips #1 screwdriver, remove the three 3mm screws from the power board.
Lift power board to remove it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
William Michaud
Member since: 03/20/2018
343 Reputation
3 Guides authored
Badges:
4
+1 more badge
Team
UMass Dartmouth, Team S5-G6, Peak Spring 2018
Member of UMass Dartmouth, Team S5-G6, Peak Spring 2018
UMASSD-PEAK-S18S5G6
3 Members
8 Guides authored
