Acer Aspire E1 531 2438 Wifi Card Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          6 minutes

Sections

Battery
2 steps
WiFi Card
4 steps

Flags

BackAcer Aspire E1-531-2438
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Unplug and power down the device before removing the battery.
Turn the device over so the back side is facing up.
Using a spudger, slide the orange latch to the right. This will release the battery, which should pop up from the device.
Use two hands tilt the side of the battery closest to the orange latch upward as shown in the images.

Unplug and power down the device before removing the battery.

Turn the device over so the back side is facing up.

Using a spudger, slide the orange latch to the right. This will release the battery, which should pop up from the device.

Use two hands tilt the side of the battery closest to the orange latch upward as shown in the images.

1024

Step 2

Tilt the side of the battery closest to the orange latch upward.
Lift the battery up and out of the device.

Tilt the side of the battery closest to the orange latch upward.

Lift the battery up and out of the device.

Step 3

              WiFi Card

Using a Phillips #0 screwdriver, remove the two 9mm screws on the access panel.

Using a Phillips #0 screwdriver, remove the two 9mm screws on the access panel.

Step 4

Using the indentation, pry open the access panel with your fingers or a spudger.
Remove the access panel to expose the hard drive, WiFi card, and RAM modules.

Using the indentation, pry open the access panel with your fingers or a spudger.

Remove the access panel to expose the hard drive, WiFi card, and RAM modules.

Step 5

Using a spudger, disconnect the two antenna cables connectors on the WiFi card.

Using a spudger, disconnect the two antenna cables connectors on the WiFi card.

Step 6

Using a Phillips #0 screwdriver, remove the 3mm screw holding the WiFi card in place.
The card will then lift up after the screw is removed.
Remove the card by pulling out in the direction that the card is now orientated.

Using a Phillips #0 screwdriver, remove the 3mm screw holding the WiFi card in place.

The card will then lift up after the screw is removed.

Remove the card by pulling out in the direction that the card is now orientated.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Jakob Rinkus

Member since: 03/21/2019

947 Reputation

                                      7 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team S8-G2, Bailey Spring 2019                        

                                                  Member of UMass Dartmouth, Team S8-G2, Bailey Spring 2019 



                    UMASSD-BAILEY-S19S8G2                     


                                            3 Members                     


                                            7 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team