Acer Aspire Es1 512 C96S Battery Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 15 minutes

Sections

Battery
4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

BackAcer Aspire ES1-512-C96S
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Removing the Screws and Opening it Up

Place the device upside down on a flat, soft surface.
Using a Phillips #0 screwdriver, remove all 18 screws that secure the bottom cover of the device.
Once all screws are removed, flip laptop back over and open it.
Begin prying in the corners and use a spluger to pry around the edge. Hearing popping noises from the plastic is normal.

Place the device upside down on a flat, soft surface.

Using a Phillips #0 screwdriver, remove all 18 screws that secure the bottom cover of the device.

Once all screws are removed, flip laptop back over and open it.

Begin prying in the corners and use a spluger to pry around the edge. Hearing popping noises from the plastic is normal.

1024

Step 2

              Lifting Keyboard

Lift Slowly, once you have popped all the plastic off the bottom case. Do not lift off completely
There are 2 ribbon cables are connecting the keyboard and Touch pad to the Motherboard.

Lift Slowly, once you have popped all the plastic off the bottom case. Do not lift off completely

There are 2 ribbon cables are connecting the keyboard and Touch pad to the Motherboard.

Step 3

              Disconnecting Keyboard and Touchpad Cables

Locate the lock for the larger Ribbon cable on the sides of the cable. Slide them back, Gently, until they release the cable. The lock may fall off, that’s okay. It will reattach.
Notice the lock bar is off of the connector.
The smaller ribbon cable has a latch, that is pulled upward, gently, until it disengages.
Now the Keyboard should remove completely.

Locate the lock for the larger Ribbon cable on the sides of the cable. Slide them back, Gently, until they release the cable. The lock may fall off, that’s okay. It will reattach.

Notice the lock bar is off of the connector.

The smaller ribbon cable has a latch, that is pulled upward, gently, until it disengages.

Now the Keyboard should remove completely.

Step 4

              Removing Battery from locks

Disconnect the Battery from the Motherboard and there is 1 screw, PH0, that is holding the battery in place.
There are also several tabs that are holding the battery in place. Bend the tabs down slightly, just enough to disengage them.
Once all locking tabs have been moved, lift from bottom and pull out.

Disconnect the Battery from the Motherboard and there is 1 screw, PH0, that is holding the battery in place.

There are also several tabs that are holding the battery in place. Bend the tabs down slightly, just enough to disengage them.

Once all locking tabs have been moved, lift from bottom and pull out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Zelik Cosio-Altamirano

Member since: 04/23/2021

153 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Member-Contributed Guide#

Introduction#

What you need#

#

#

#

#

#

#

Member-Contributed Guide

Introduction

What you need