Difficulty

Easy

Steps

6

Time Required

                          5 minutes

Sections

2

  • Battery
  • 4 steps
  • Fan
  • 2 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackAcer Aspire ES1-711-P1UV

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Place the laptop face down on a flat, clean surface.
  • Remove all twenty-seven 7 mm screws on the back cover of the laptop with a Phillips #0 screwdriver. Screws are circled in red on the diagram.

Place the laptop face down on a flat, clean surface.

Remove all twenty-seven 7 mm screws on the back cover of the laptop with a Phillips #0 screwdriver. Screws are circled in red on the diagram.

1024

Step 2

  • Use the iFixit opening tool to pry open the four corners of the back cover of the laptop. You may need to use your hands to fully remove the cover.
  • Be sure to evenly apply pressure when removing the back cover.

Use the iFixit opening tool to pry open the four corners of the back cover of the laptop. You may need to use your hands to fully remove the cover.

Be sure to evenly apply pressure when removing the back cover.

Step 3

  • Remove the two 5 mm screws located on either side of the battery.

Remove the two 5 mm screws located on either side of the battery.

Step 4

  • Disconnect the colored bundled cable connectors from the motherboard. To do this, pull on the wires to disconnect the cable and remove the battery.

Disconnect the colored bundled cable connectors from the motherboard. To do this, pull on the wires to disconnect the cable and remove the battery.

Step 5

              Fan
  • Locate and remove the 5 mm screw using the Phillips #0 screwdriver.
  • Unscrew the four 5mm screws still holding down the fan.
  • The four 5mm screws in the second part of this step cannot be fully removed from the fan. Loosen them and continue on to Step 6.

Locate and remove the 5 mm screw using the Phillips #0 screwdriver.

Unscrew the four 5mm screws still holding down the fan.

The four 5mm screws in the second part of this step cannot be fully removed from the fan. Loosen them and continue on to Step 6.

Step 6

  • Disconnect the red, white, black, and yellow bundled cable connectors from the motherboard by gently pulling them.
  • Remove the fan assembly.

Disconnect the red, white, black, and yellow bundled cable connectors from the motherboard by gently pulling them.

Remove the fan assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Lindsay O'Shea

Member since: 03/22/2018

414 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Sam Houston State, Team S17-G3, Blackburne Spring 2018                        

                                                  Member of Sam Houston State, Team S17-G3, Blackburne Spring 2018 



                    SHSU-BLACKBURNE-S18S17G3                     


                                            3 Members                     


                                            3 Guides authored