Difficulty
Difficult
Steps
12
Time Required
15 minutes
Sections
2
- Battery
- 5 steps
- Screen
- 7 steps
Flags
0
BackAcer Aspire One 722
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before using this guide, inspect the screen for debris that may be interfering with the visual quality. Be sure to test the quality of the screen by turning on the device to confirm the screen is faulty and is in need of replacement.
Step 5 requires you to slowly remove the glass casing from the device. Visit your local electronics store that recycles used materials to safely dispose of the faulty screen.
Before beginning, make sure to power off your device completely and disconnect from any external power source.
What you need
Step 1
Battery
- Power down the netbook by pressing the power button on the top left corner.
Power down the netbook by pressing the power button on the top left corner.
1024
Step 2
- Close the netbook and flip it over so that the back is facing up.
Close the netbook and flip it over so that the back is facing up.
Step 3
- Slide the button below the battery to the right while simultaneously pulling the battery out.
Slide the button below the battery to the right while simultaneously pulling the battery out.
Step 4
- If necessary, remove the old battery and replace it with a new one.
If necessary, remove the old battery and replace it with a new one.
Step 5
- Check the thin grooves on the side of the battery entry and line the replacement battery up to the grooves.
Check the thin grooves on the side of the battery entry and line the replacement battery up to the grooves.
Step 6
Screen
- Remove the black rubber clips from the bottom right and left of the netbook screen.
Remove the black rubber clips from the bottom right and left of the netbook screen.
Step 7
- Remove the screws under the black caps.
Remove the screws under the black caps.
Step 8
- Slowly separate the screen casing from the screen.
- Potential for device damage: Be careful when detaching the screen casing from the screen. If not done slowly, it can break.
Slowly separate the screen casing from the screen.
Potential for device damage: Be careful when detaching the screen casing from the screen. If not done slowly, it can break.
Step 9
- Remove the screws located on the four corners of the screen.
Remove the screws located on the four corners of the screen.
Step 10
- Remove the two bottom screws.
- Taking out these screws will allow you to remove the screen from its attachment.
Remove the two bottom screws.
Taking out these screws will allow you to remove the screen from its attachment.
Step 11
- On the bottom left of the screen there is a cord attached. Remove the tape that is attached to the screen.
On the bottom left of the screen there is a cord attached. Remove the tape that is attached to the screen.
Step 12
- On the green board, remove the two screws.
- Remove the board.
On the green board, remove the two screws.
Remove the board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Christian Barboza
Member since: 10/25/2015
818 Reputation
5 Guides authored
Badges:
13
+10 more badges
Team
UMass Dartmouth, Team 5-6, Gulbrandsen Fall 2015
Member of UMass Dartmouth, Team 5-6, Gulbrandsen Fall 2015
UMASSD-GULBRANDSEN-F15S5G6
3 Members
10 Guides authored