Difficulty

Moderate

Steps

10

Time Required

                          3 - 5 minutes

Sections

3

  • Back Panel
  • 2 steps
  • Battery
  • 3 steps
  • Display
  • 5 steps

Flags

0

  • BackAcer Aspire One Cloudbook 14 AO1-431-C8G8

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Remove the ten 7mm Phillips #0 screws from the bottom.

Remove the ten 7mm Phillips #0 screws from the bottom.

1024

Step 2

  • Insert a plastic opening tool under the bottom cover and slid it around the perimeter until all of the clips release.

Insert a plastic opening tool under the bottom cover and slid it around the perimeter until all of the clips release.

Step 3

              Battery
  • Remove the two 5mm Phillips #0 screws from the battery.

Remove the two 5mm Phillips #0 screws from the battery.

Step 4

  • Use a spudger to flip up the retaining flaps on the ribbon cable ZIF sockets.
  • Remove the ribbon cables from the sockets.

Use a spudger to flip up the retaining flaps on the ribbon cable ZIF sockets.

Remove the ribbon cables from the sockets.

Step 5

  • Disconnect the battery from the motherboard.
  • Remove the battery.

Disconnect the battery from the motherboard.

Remove the battery.

Step 6

              Display
  • The battery is installed in these pictures but should always be removed before any part replacement.
  • Remove the four 5mm Phillips #0 screws from the display hinge.

The battery is installed in these pictures but should always be removed before any part replacement.

Remove the four 5mm Phillips #0 screws from the display hinge.

Step 7

  • Disconnect the two antenna cables from the Wi-fi card.

Disconnect the two antenna cables from the Wi-fi card.

Step 8

  • Disconnect the display cable by pulling it down and towards you.

Disconnect the display cable by pulling it down and towards you.

Step 9

  • Lift the bottom half of the computer away from the screen while keeping the screen flat on the table surface.
  • This will allow the hinges holding the screen in place to lift up.

Lift the bottom half of the computer away from the screen while keeping the screen flat on the table surface.

This will allow the hinges holding the screen in place to lift up.

Step 10

  • While the screen is flat on the surface, slide the bottom half of the computer towards the top of the screen to separate the two halves.
  • The screen is now completely removed from the bottom half of the computer.

While the screen is flat on the surface, slide the bottom half of the computer towards the top of the screen to separate the two halves.

The screen is now completely removed from the bottom half of the computer.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Joseph

Member since: 01/25/2018

637 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team S20-G1, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S20-G1, Passmore Spring 2018 



                    USFT-PASSMORE-S18S20G1                     


                                            3 Members                     


                                            6 Guides authored