Difficulty
Moderate
Steps
8
Time Required
Suggest a time??
Sections
3
- Keyboard
- 4 steps
- Back Panel
- 3 steps
- RAM
- 1 step
Flags
0
BackAcer Aspire One D255E
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Keyboard
- Start by removing the battery found on the back of the device.
- The battery must be removed in order to ensure the device does not have power! Make sure you do not skip this step!
Start by removing the battery found on the back of the device.
The battery must be removed in order to ensure the device does not have power! Make sure you do not skip this step!
1024
Step 2
- Using plastic opening tools press down the 6 clips located around the keyboard.
Using plastic opening tools press down the 6 clips located around the keyboard.
Step 3
- Using a plastic opening tool or spudger move the keyboard out of position.
- There is a thin cable on the backside of the keyboard. Make sure when you move the keyboard out of position you do so slowly to prevent damage to this cable.
- If you use a spudger it is recommended that you use a plastic spudger to reduce the chance of damaging any internal parts.
Using a plastic opening tool or spudger move the keyboard out of position.
There is a thin cable on the backside of the keyboard. Make sure when you move the keyboard out of position you do so slowly to prevent damage to this cable.
If you use a spudger it is recommended that you use a plastic spudger to reduce the chance of damaging any internal parts.
Step 4
- Using a spudger gently push the tab on the port forward then pull out the cable.
- Be careful to do so as gently as possible. You do not want to damage the port.
Using a spudger gently push the tab on the port forward then pull out the cable.
Be careful to do so as gently as possible. You do not want to damage the port.
Step 5
Back Panel
- Unscrew seven 1.2 mm Phillips #1 screws from the back of the device
Unscrew seven 1.2 mm Phillips #1 screws from the back of the device
Step 6
- Unscrew eight more 1.2 mm Phillips #1 screws from the front of the computer.
Unscrew eight more 1.2 mm Phillips #1 screws from the front of the computer.
Step 7
- Using a spudger carefully push though the hole to dislodge the panel on the back of the device then remove the panel by hand.
- It is recommended that you use a plastic spudger to reduce the chance of damaging any internal parts.
Using a spudger carefully push though the hole to dislodge the panel on the back of the device then remove the panel by hand.
It is recommended that you use a plastic spudger to reduce the chance of damaging any internal parts.
Step 8
RAM
- Using your hands pull apart the two clips holding the RAM in then pull out the RAM.
- It uses (DDR3) 204pin PC3-10600 1333MHz DDR3 SO-DIMM Memory Modules
Using your hands pull apart the two clips holding the RAM in then pull out the RAM.
It uses (DDR3) 204pin PC3-10600 1333MHz DDR3 SO-DIMM Memory Modules
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
7 other people completed this guide.
Author
with 2 other contributors
Brian
Member since: 03/19/2016
1,224 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team 16-8, Bhusal Spring 2016
Member of UMass Dartmouth, Team 16-8, Bhusal Spring 2016
UMASSD-BHUSAL-S16S16G8
2 Members
10 Guides authored
