Acer Aspire Switch 10 Sw5 012 18My Power Light Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes            

Sections

1

• Power Light
• 7 steps

Flags

0

• BackAcer Aspire Switch 10 SW5-012-18MY

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Light               

• Remove the tablet from the keyboard.
• You will not be needing the keyboard for this guide.

Remove the tablet from the keyboard.

You will not be needing the keyboard for this guide.

1024

Step 2

• Use the opening tool to open the back cover. The opening tool should fit under the cover if you place it above the power button, as shown in the pictures.
• Lift this side of the back cover once the opening tool is inside the device, as shown in the third picture.
• Use the opening tool and your hands to gradually work around the edges of the cover.

Use the opening tool to open the back cover. The opening tool should fit under the cover if you place it above the power button, as shown in the pictures.

Lift this side of the back cover once the opening tool is inside the device, as shown in the third picture.

Use the opening tool and your hands to gradually work around the edges of the cover.

Step 3

• Lift the back cover off of the device with your hands.
• You will need to use some force to pull off the back cover.

Lift the back cover off of the device with your hands.

You will need to use some force to pull off the back cover.

Step 4

• Remove the piece of black, thin tape that is attached to the circuit board closest to the power button.

Remove the piece of black, thin tape that is attached to the circuit board closest to the power button.

Step 5

• Use the opening tool to lift the black ZIF connector holding the ribbon cable in place.
• Pull out the ribbon cable from the circuit board. This cable should have the word “Audio” on it.

Use the opening tool to lift the black ZIF connector holding the ribbon cable in place.

Pull out the ribbon cable from the circuit board. This cable should have the word “Audio” on it.

Step 6

• Use the screwdriver to remove the 3, 3 mm screws on the circuit board.

Use the screwdriver to remove the 3, 3 mm screws on the circuit board.

Step 7

• Carefully remove the circuit board from the device. The power light is located on this board.
• The power light is attached to this circuit board you have just removed. To replace the power light on this piece, please go to the page How To Solder and Desolder Connections.

Carefully remove the circuit board from the device. The power light is located on this board.

The power light is attached to this circuit board you have just removed. To replace the power light on this piece, please go to the page How To Solder and Desolder Connections.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Grecia Corrada                     

Member since: 03/19/2018

1,092 Reputation

                                      6 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       Baylor, Team S3-G3, Williams Spring 2018                        

                                                  Member of Baylor, Team S3-G3, Williams Spring 2018 



                    BU-WILLIAMS-S18S3G3                     


                                            3 Members                     


                                            6 Guides authored