Difficulty

Moderate

Steps

11

Time Required

                          9 minutes            

Sections

5

  • Lower Back Panel
  • 1 step
  • RAM
  • 1 step
  • Keyboard
  • 4 steps
  • Battery
  • 2 steps
  • Audio Port/USB Drive
  • 3 steps

Flags

0

  • BackAcer Aspire TimelineX 4830T-6682

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

This guide provides simple steps to replace the Audio Port/USB Drive on the Acer Aspire TimelineX 4830T-6682 using minimal tools that can be acquired locally, or through iFixit. Please make sure and follow the prerequisite procedures.

What you need

Step 1

              Lower Back Panel               
  • Remove the single screw with a Phillips #0 screwdriver.
  • Use a plastic opening tool on the upper part of the panel to remove it and access the RAM.
  • The other way to remove the panel is by sliding it away from the laptop. The difficulty of sliding it depends on the condition of your laptop.

Remove the single screw with a Phillips #0 screwdriver.

Use a plastic opening tool on the upper part of the panel to remove it and access the RAM.

The other way to remove the panel is by sliding it away from the laptop. The difficulty of sliding it depends on the condition of your laptop.

1024

Step 2

              RAM               
  • After the panel has been removed, locate the RAM. It should be on the lower right.
  • There are pins around the RAM that need to be pulled back. After the pins are removed, pull the RAM chip towards you to remove it.

After the panel has been removed, locate the RAM. It should be on the lower right.

There are pins around the RAM that need to be pulled back. After the pins are removed, pull the RAM chip towards you to remove it.

Step 3

              Keyboard               
  • Remove the eleven screws that hold that back panel to the laptop using a J0 Phillips screwdriver bit.

Remove the eleven screws that hold that back panel to the laptop using a J0 Phillips screwdriver bit.

Step 4

  • Place the laptop in the upright position, the lower front touchpad panel should be easily detatched at this point.
  • Remove the lower front touchpad panel by using an angled tweezers to disconnect the only wired tape connected to the motherboard.

Place the laptop in the upright position, the lower front touchpad panel should be easily detatched at this point.

Remove the lower front touchpad panel by using an angled tweezers to disconnect the only wired tape connected to the motherboard.

Step 5

  • Next, disconnect the 4 wired tapes of the keyboard from the motherboard just like we did with the lower front touchpad panel.

Next, disconnect the 4 wired tapes of the keyboard from the motherboard just like we did with the lower front touchpad panel.

Step 6

  • Finally, using an opening tool, gently pry along the edge of the keyboard to separate it from the laptop.

Finally, using an opening tool, gently pry along the edge of the keyboard to separate it from the laptop.

Step 7

              Battery               
  • The battery will be on the side closest to the screen.
  • Gently lift it out. It will still be attached by white, red, and black wires.

The battery will be on the side closest to the screen.

Gently lift it out. It will still be attached by white, red, and black wires.

Step 8

  • Pull the white plug, it should easily detach.
  • Remove the battery from the device.

Pull the white plug, it should easily detach.

Remove the battery from the device.

Step 9

              Audio Port/USB Drive               
  • Pry the black locking clip of the Port/USB Drive upwards with tweezers to release the ribbon cable

Pry the black locking clip of the Port/USB Drive upwards with tweezers to release the ribbon cable

Step 10

  • Remove the 3.6mm by 1.9mm screws from the Audio Port/USB Drive using a Phillips #1 screwdriver

Remove the 3.6mm by 1.9mm screws from the Audio Port/USB Drive using a Phillips #1 screwdriver

Step 11

  • Remove the Audio Port/USB Drive from the laptop chassis

Remove the Audio Port/USB Drive from the laptop chassis

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Jon Brunsell                     

Member since: 07/10/2019

592 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       IUPUI, Team S1-G1, Beck Spring 2020                        

                                                  Member of IUPUI, Team S1-G1, Beck Spring 2020 



                    IUPUI-BECK-S20S1G1                     


                                            3 Members                     


                                            6 Guides authored