Acer Aspire V5 122P 0889 Network Card Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          3 - 15 minutes

Sections

Battery
6 steps
Network Card
3 steps

Flags

BackAcer Aspire V5-122P-0889
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Start the process of removing the bottom cover of the laptop by unscrewing the 8mm screws in the top right and left corners.
Remove the remaining 9 visible screws, which are 5mm in length.
Every screw in this laptop can be removed with a Phillips #0 screwdriver.

Start the process of removing the bottom cover of the laptop by unscrewing the 8mm screws in the top right and left corners.

Remove the remaining 9 visible screws, which are 5mm in length.

Every screw in this laptop can be removed with a Phillips #0 screwdriver.

1024

Step 2

Towards the top right corner of the laptop, there is a rubber piece covering the final screw holding the cover on, as well as a set of pins. Use your fingernail to remove this piece of rubber, and then unscrew the hidden 5mm screw.

Towards the top right corner of the laptop, there is a rubber piece covering the final screw holding the cover on, as well as a set of pins. Use your fingernail to remove this piece of rubber, and then unscrew the hidden 5mm screw.

Step 3

Going around the edges of the laptop, apply light to moderate amounts of pressure away from the laptop to unseat the cover so that it can be removed. Once you have removed the cover, place it face-up in a safe place to avoid getting the inside of the cover dirty.
If you are having trouble unseating the cover by hand, a nylon spudger can be run around the perimeter of the laptop to help lift the cover away from the case.

Going around the edges of the laptop, apply light to moderate amounts of pressure away from the laptop to unseat the cover so that it can be removed. Once you have removed the cover, place it face-up in a safe place to avoid getting the inside of the cover dirty.

If you are having trouble unseating the cover by hand, a nylon spudger can be run around the perimeter of the laptop to help lift the cover away from the case.

Step 4

Carefully unscrew the two 5mm screws holding the battery in place.

Carefully unscrew the two 5mm screws holding the battery in place.

Step 5

Carefully use light upward pressure to unseat the battery from the case, but do not pull on the cord or try and completely remove the battery from the case.

Carefully use light upward pressure to unseat the battery from the case, but do not pull on the cord or try and completely remove the battery from the case.

Step 6

Finally, disconnect the battery from the motherboard by undoing the power connector. To undo the connector, simply apply light to moderate pull on the sides of the connector.

Finally, disconnect the battery from the motherboard by undoing the power connector. To undo the connector, simply apply light to moderate pull on the sides of the connector.

Step 7

              Network Card

Start by removing the antenna cable attached to the network card.

Start by removing the antenna cable attached to the network card.

Step 8

Unscrew the two 3mm screws holding the network card in place.

Unscrew the two 3mm screws holding the network card in place.

Step 9

Carefully remove the network card by pulling it backwards, out of the slot that it is plugged into.

Carefully remove the network card by pulling it backwards, out of the slot that it is plugged into.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Katelynn couto

Member since: 03/07/2016

675 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       UMass Dartmouth, Team 5-1, Landers Spring 2016                        

                                                  Member of UMass Dartmouth, Team 5-1, Landers Spring 2016 



                    UMASSD-LANDERS-S16S5G1                     


                                            3 Members                     


                                            10 Guides authored

Vibra - Aug 20, 2017

Why you should quite battery to take out the wifi card?

Regards

Cyrus Fox - Mar 25, 2021

Agreed, no need to pull battery to pull the wifi card, make sure you are ground and you are good to pull and replace.

Introduction#

What you need#

Team#

Introduction

What you need

Team