Acer Aspire V5 591G 75Ke Disassembly Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Acer Aspire V5-591G-75KE Disassembly
4 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackAcer Aspire V5-591G-75KE
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Acer Aspire V5-591G-75KE Disassembly

Close down the display and flip the device upside down.
Use a Phillips #1 screwdriver to remove 18 black 10mm Phillips Head screws in order to loosen up the protective bottom casing.

Close down the display and flip the device upside down.

Use a Phillips #1 screwdriver to remove 18 black 10mm Phillips Head screws in order to loosen up the protective bottom casing.

1024

Step 2

With the screws removed, flip the device right-side up and open up the display.
Run a plastic spudger tool along the seam of the face-plate in order to loosen up the protective bottom casing.
Popping sounds are normal, but forceful prying can damage delicate components. Be especially careful near the USB and HDMI ports.

With the screws removed, flip the device right-side up and open up the display.

Run a plastic spudger tool along the seam of the face-plate in order to loosen up the protective bottom casing.

Popping sounds are normal, but forceful prying can damage delicate components. Be especially careful near the USB and HDMI ports.

Step 3

Close the display down once more, and flip the laptop upside down, with the hinge facing away from you.
Do not yank the bottom casing off. There is a small speaker wire that connects it to the motherboard.
Taking note of the small speaker wire, gently lift only the left side of the bottom casing.

Close the display down once more, and flip the laptop upside down, with the hinge facing away from you.

Do not yank the bottom casing off. There is a small speaker wire that connects it to the motherboard.

Taking note of the small speaker wire, gently lift only the left side of the bottom casing.

Step 4

Using a pair of blunt tweezers, push on the tabs of the small white connector to separate it from the motherboard.
The entire bottom casing should lift with no resistance. If there is too much resistance, verify you removed all the screws, and run the plastic spudger tool around the face-plate again.

Using a pair of blunt tweezers, push on the tabs of the small white connector to separate it from the motherboard.

The entire bottom casing should lift with no resistance. If there is too much resistance, verify you removed all the screws, and run the plastic spudger tool around the face-plate again.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Tasier Hagler

Member since: 10/18/2017

422 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UW Tacoma, Team S3-G5, Liner Fall 2017                        

                                                  Member of UW Tacoma, Team S3-G5, Liner Fall 2017 



                    UWT-LINER-F17S3G5                     


                                            4 Members                     


                                            18 Guides authored

Better Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Better Introduction

What you need

Team