Difficulty
Moderate
Steps
6
Time Required
30 - 50 minutes
Sections
3
- Back Cover
- 1 step
- Battery
- 3 steps
- Touchpad
- 2 steps
Flags
4
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Better Introduction
Improve this guide by completing or revising its introduction.
BackAcer Chromebook R11 C738T-C44Z
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before starting the replacement process, make sure to shut down your laptop and drain any residual power. After doing so, continue to the replacement instructions below.
What you need
Step 1
Back Cover
- Lay the laptop with the back side up.
- Use a Phillips #1 screwdriver to remove eleven 3 mm screws.
- Use the opening tool to pry the back cover off gently by placing it in the seam and working your way around the perimeter.
Lay the laptop with the back side up.
Use a Phillips #1 screwdriver to remove eleven 3 mm screws.
Use the opening tool to pry the back cover off gently by placing it in the seam and working your way around the perimeter.
1024
Step 2
Battery
- Unplug the battery connector from the motherboard. (The motherboard is a group of wires in rainbow colors)
- Use a Phillips #1 screwdriver to remove the two 3 mm screws, (one on each side of the battery), that secure it in place.
Unplug the battery connector from the motherboard. (The motherboard is a group of wires in rainbow colors)
Use a Phillips #1 screwdriver to remove the two 3 mm screws, (one on each side of the battery), that secure it in place.
Step 3
- Remove battery from its holder by pulling it upwards from the device
- Attempt to remove it as gently as possible to avoid damaging the Motherboard
Remove battery from its holder by pulling it upwards from the device
Attempt to remove it as gently as possible to avoid damaging the Motherboard
Step 4
- Install the new battery and again use a Phillips #1 screwdriver to remove the two 3 mm screws
Install the new battery and again use a Phillips #1 screwdriver to remove the two 3 mm screws
Step 5
Touchpad
- Use a Phillips #1 screwdriver to remove the three 3 mm screws that secure the touchpad.
- Lift up the tab for the cable cord.
- Pull out the touchpad connector.
Use a Phillips #1 screwdriver to remove the three 3 mm screws that secure the touchpad.
Lift up the tab for the cable cord.
Pull out the touchpad connector.
Step 6
- Pull the left piece of tape up by prying it up with your fingers or with the screwdriver.
- Be gentle to not rip the tape.
- Next, pull up the other piece of tape.
- Remove the touchpad.
Pull the left piece of tape up by prying it up with your fingers or with the screwdriver.
Be gentle to not rip the tape.
Next, pull up the other piece of tape.
Remove the touchpad.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Connie Hernandez
Member since: 09/01/2021
511 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
Gateway, Team 1-4, Saknee Fall 2021
Member of Gateway, Team 1-4, Saknee Fall 2021
GCC-SAKNEE-F21S1G4
4 Members
6 Guides authored
