Difficulty

Moderate

Steps

5

Time Required

                          5 - 10 minutes

Sections

1

  • Battery
  • 5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackAcer Iconia A100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Start at any side of the tablet.
  • Begin to take apart the tablet with a plastic opening tool along the sides of the tablet.
  • Work your way around the tablet.
  • There are four side pieces in total.

Start at any side of the tablet.

Begin to take apart the tablet with a plastic opening tool along the sides of the tablet.

Work your way around the tablet.

There are four side pieces in total.

1024

Step 2

  • Remove the five 4 mm screws from the edges of the tablet with a Phillips #00 screwdriver.

Remove the five 4 mm screws from the edges of the tablet with a Phillips #00 screwdriver.

Step 3

  • Carefully separate the back piece from the device using a plastic opening tool.
  • Remember to open along the entire perimeter of the tablet.

Carefully separate the back piece from the device using a plastic opening tool.

Remember to open along the entire perimeter of the tablet.

Step 4

  • Turn the tablet over so that the battery is facing upwards.
  • Remove the four 4mm screws located around the battery.

Turn the tablet over so that the battery is facing upwards.

Remove the four 4mm screws located around the battery.

Step 5

  • Use the tip of a plastic spudger or opening tool to gently push the connector head out of its socket.
  • Use your fingers or the flat edge of a plastic opening tool to lift the battery up and off of the device.
  • Be sure to not have any water around the device while removing the battery.
  • Be sure to be cautious while removing the battery and remove carefully; avoid ripping the wires attached to the battery.

Use the tip of a plastic spudger or opening tool to gently push the connector head out of its socket.

Use your fingers or the flat edge of a plastic opening tool to lift the battery up and off of the device.

Be sure to not have any water around the device while removing the battery.

Be sure to be cautious while removing the battery and remove carefully; avoid ripping the wires attached to the battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 7 other contributors 


                    Omar Acosta

Member since: 03/03/2015

526 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Sam Houston State, Team 13-3, Blackburne Winter 2015                        

                                                  Member of Sam Houston State, Team 13-3, Blackburne Winter 2015 



                    SHSU-BLACKBURNE-W15S13G3                     


                                            1 Member                     


                                            3 Guides authored