Acer Iconia One 10 B3 A30 Repair Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          2 - 6 minutes            

Sections

2

• Battery
• 5 steps
• Motherboard
• 4 steps

Flags

0

• BackAcer Iconia One 10 B3-A30

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Make sure the device is powered off.
• Open media port cover at the top of the tablet.
• Use the Phillips #00 screwdriver to remove the 1 mm screw.

Make sure the device is powered off.

Open media port cover at the top of the tablet.

Use the Phillips #00 screwdriver to remove the 1 mm screw.

1024

Step 2

• Using the metal spudger, carefully pry open the back cover.

Using the metal spudger, carefully pry open the back cover.

Step 3

• Remove small section of grey tape.

Remove small section of grey tape.

Step 4

• Unplug the connection cord from the motherboard.

Unplug the connection cord from the motherboard.

Step 5

• Try to remove the battery by pulling on the blue tabs.
• If unsuccessful, use the black plastic spudger to gently break the glue bonds underneath and pull up to remove the battery.
• Be very cautious not to puncture or bend the battery.

Try to remove the battery by pulling on the blue tabs.

If unsuccessful, use the black plastic spudger to gently break the glue bonds underneath and pull up to remove the battery.

Be very cautious not to puncture or bend the battery.

Step 6

              Motherboard               

• Remove all of the tape surrounding the motherboard.

Remove all of the tape surrounding the motherboard.

Step 7

• Starting with the 2 large connections use the plastic opening tool to gently pry on the connections and pop them out.
• Now, disconnect the two smaller black and red cords from the motherboard.

Starting with the 2 large connections use the plastic opening tool to gently pry on the connections and pop them out.

Now, disconnect the two smaller black and red cords from the motherboard.

Step 8

• Scrape away the small square sticker to reveal one small screw. Use the Phillips #00 screwdriver to remove the screw.
• Using the same screwdriver remove the other three screws on the motherboard.

Scrape away the small square sticker to reveal one small screw. Use the Phillips #00 screwdriver to remove the screw.

Using the same screwdriver remove the other three screws on the motherboard.

Step 9

• Using the small plastic tool, carefully pry the motherboard out of the device.

Using the small plastic tool, carefully pry the motherboard out of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 4 other contributors 

                    Austin Pickart                     

Member since: 09/28/2017

688 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       USF Tampa, Team S1-G5, Nance Fall 2017                        

                                                  Member of USF Tampa, Team S1-G5, Nance Fall 2017 



                    USFT-NANCE-F17S1G5                     


                                            4 Members                     


                                            5 Guides authored                     

Craig Olmscheid - Sep 19, 2020

Reply

The button flex cable retaining clip is broken, do you have this available?