Difficulty

Easy

Steps

7

Time Required

                          15 minutes

Sections

2

  • Battery
  • 5 steps
  • Microphone
  • 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackAcer Iconia Tab A200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • With the plastic opening tool pry open the grey plastic siding on both sides of the tablet.

With the plastic opening tool pry open the grey plastic siding on both sides of the tablet.

1024

Step 2

  • Using a Phillips #00 screwdriver remove the 4.0 mm screws on the sides of the tablet.
  • There are two screws on each side of the tablet that need to be removed before the back casing can be removed.

Using a Phillips #00 screwdriver remove the 4.0 mm screws on the sides of the tablet.

There are two screws on each side of the tablet that need to be removed before the back casing can be removed.

Step 3

  • Once the 4 screws have been removed use the plastic opening tool to pry open the device on the side of the device.
  • Be careful prying on the sides where you removed the screw as the plastic casing is not very strong and may break.
  • After prying open the case with the plastic opening tool carefully remove the case from the device and place the device face down on its screen.

Once the 4 screws have been removed use the plastic opening tool to pry open the device on the side of the device.

Be careful prying on the sides where you removed the screw as the plastic casing is not very strong and may break.

After prying open the case with the plastic opening tool carefully remove the case from the device and place the device face down on its screen.

Step 4

  • Using a Phillips #00 screwdriver remove the 4.0 mm screws holding the battery in place.

Using a Phillips #00 screwdriver remove the 4.0 mm screws holding the battery in place.

Step 5

  • Lift the battery out of the device, and disconnect the cable attached to the motherboard by pulling it out to the side not lifting it up.

Lift the battery out of the device, and disconnect the cable attached to the motherboard by pulling it out to the side not lifting it up.

Step 6

              Microphone
  • Lift up on the microphone cable to lift the microphone component away from the case.

Lift up on the microphone cable to lift the microphone component away from the case.

Step 7

  • Once the microphone has been lifted away from the case, disconnect the microphone cable from the motherboard by pulling the cable out horizontally. Do not lift up to remove.

Once the microphone has been lifted away from the case, disconnect the microphone cable from the motherboard by pulling the cable out horizontally. Do not lift up to remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jaimie Payne

Member since: 03/06/2016

477 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team 5-5, Landers Spring 2016                        

                                                  Member of UMass Dartmouth, Team 5-5, Landers Spring 2016 



                    UMASSD-LANDERS-S16S5G5                     


                                            3 Members                     


                                            6 Guides authored