Acer Iconia Tab A200 Speaker Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          15 minutes

Sections

Battery
5 steps
Speaker
3 steps

Flags

BackAcer Iconia Tab A200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

With the plastic opening tool pry open the grey plastic siding on both sides of the tablet.

With the plastic opening tool pry open the grey plastic siding on both sides of the tablet.

1024

Step 2

Using a Phillips #00 screwdriver remove the 4.0 mm screws on the sides of the tablet.
There are two screws on each side of the tablet that need to be removed before the back casing can be removed.

Using a Phillips #00 screwdriver remove the 4.0 mm screws on the sides of the tablet.

There are two screws on each side of the tablet that need to be removed before the back casing can be removed.

Step 3

Once the 4 screws have been removed use the plastic opening tool to pry open the device on the side of the device.
Be careful prying on the sides where you removed the screw as the plastic casing is not very strong and may break.
After prying open the case with the plastic opening tool carefully remove the case from the device and place the device face down on its screen.

Once the 4 screws have been removed use the plastic opening tool to pry open the device on the side of the device.

Be careful prying on the sides where you removed the screw as the plastic casing is not very strong and may break.

After prying open the case with the plastic opening tool carefully remove the case from the device and place the device face down on its screen.

Step 4

Using a Phillips #00 screwdriver remove the 4.0 mm screws holding the battery in place.

Using a Phillips #00 screwdriver remove the 4.0 mm screws holding the battery in place.

Step 5

Lift the battery out of the device, and disconnect the cable attached to the motherboard by pulling it out to the side not lifting it up.

Lift the battery out of the device, and disconnect the cable attached to the motherboard by pulling it out to the side not lifting it up.

Step 6

              Speaker

After removing the battery use a Phillips head #00 screwdriver to remove the 3.0 mm screws holding the dual speakers in place.

After removing the battery use a Phillips head #00 screwdriver to remove the 3.0 mm screws holding the dual speakers in place.

Step 7

Once the screws are removed, lift up on the speakers to remove them from the case.

Once the screws are removed, lift up on the speakers to remove them from the case.

Step 8

Once you have removed the speakers from the case, disconnect the speakers from the motherboard by pulling the cable out horizontally. Do not pull up on the cable.

Once you have removed the speakers from the case, disconnect the speakers from the motherboard by pulling the cable out horizontally. Do not pull up on the cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Steve Chiu

Member since: 03/11/2016

253 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team 5-5, Landers Spring 2016                        

                                                  Member of UMass Dartmouth, Team 5-5, Landers Spring 2016 



                    UMASSD-LANDERS-S16S5G5                     


                                            3 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team