Acer Iconia Tab A501 Usb A Micro Usb Port Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          10 - 15 minutes            

Sections

2

• Back Cover
• 2 steps
• USB-A/Micro-USB Port
• 4 steps

Flags

0

• BackAcer Iconia Tab A501

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Cover               

• Turn off your device before opening it.
• Use a plastic opening tool to carefully separate the back cover, starting at the volume buttons.
• Continue separating the back cover along the short side closest to the camera and around the device.

Turn off your device before opening it.

Use a plastic opening tool to carefully separate the back cover, starting at the volume buttons.

Continue separating the back cover along the short side closest to the camera and around the device.

1024

Step 2

• When separated enough, a little more than halfway around the device, the back cover will be easy to take off.

When separated enough, a little more than halfway around the device, the back cover will be easy to take off.

Step 3

              USB-A/Micro-USB Port               

• In the next step, be careful not to squeeze too hard or scratch the motherboard.
• Use the angled tweezers to disconnect the white motherboard-battery connector in the middle of the side opposite the docking port.

In the next step, be careful not to squeeze too hard or scratch the motherboard.

Use the angled tweezers to disconnect the white motherboard-battery connector in the middle of the side opposite the docking port.

Step 4

• Use the plastic opening tool to flip up the locking mechanism for the flat, white ribbon cable connecting to the USB ports’ board.
• Remove the flat, white ribbon cable.

Use the plastic opening tool to flip up the locking mechanism for the flat, white ribbon cable connecting to the USB ports’ board.

Remove the flat, white ribbon cable.

Step 5

• Use a Phillips #1 screwdriver to remove the two 4.0 mm Philips screws attaching the metal plate, USB board, and device.

Use a Phillips #1 screwdriver to remove the two 4.0 mm Philips screws attaching the metal plate, USB board, and device.

Step 6

• Use the Halberd Spudger to carefully pop up and take out the ports.

Use the Halberd Spudger to carefully pop up and take out the ports.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Daksh Malhotra                     

Member since: 07/08/2019

1,383 Reputation

                                      8 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S3-G1, Watkins Summer 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S3-G1, Watkins Summer 2019 



                    ERAU-WATKINS-SU19S3G1                     


                                            5 Members                     


                                            10 Guides authored