Difficulty

Easy

Steps

9

Time Required

                          4 - 6 minutes

Sections

2

  • Back Panel
  • 2 steps
  • Battery
  • 7 steps

Flags

0

  • BackAcer Iconia W3-810

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Place the tablet face down on a flat surface with the charger facing toward you.

Place the tablet face down on a flat surface with the charger facing toward you.

1024

Step 2

  • Use a plastic opening tool to pry the back panel off of the device.
  • Be careful to not use the plastic opening tool near the charging dock or any media ports.

Use a plastic opening tool to pry the back panel off of the device.

Be careful to not use the plastic opening tool near the charging dock or any media ports.

Step 3

              Battery
  • Pull the ribbon cord by pushing the clamp on the port toward you with the plastic opening tool.

Pull the ribbon cord by pushing the clamp on the port toward you with the plastic opening tool.

Step 4

  • Move the ribbon cord in order to disconnect the rainbow cord from the battery.
  • Take extra care to not rip the ribbon cord.

Move the ribbon cord in order to disconnect the rainbow cord from the battery.

Take extra care to not rip the ribbon cord.

Step 5

  • Use the plastic opening tool to carefully slide the power cord from its slot by pushing it out from both sides, then remove the cord from its port with your hand.

Use the plastic opening tool to carefully slide the power cord from its slot by pushing it out from both sides, then remove the cord from its port with your hand.

Step 6

  • Pull on the ribbon cord carefully in order to break the seal between the ribbon cord and the battery. Do this until the cord is completely free of the battery.
  • Do not pull the ribbon cord too hard or near the opposite end.

Pull on the ribbon cord carefully in order to break the seal between the ribbon cord and the battery. Do this until the cord is completely free of the battery.

Do not pull the ribbon cord too hard or near the opposite end.

Step 7

  • Use the plastic opening tool to gently wedge out and lift the battery pack from the device.

Use the plastic opening tool to gently wedge out and lift the battery pack from the device.

Step 8

  • Carefully break the bond between the inner tape and the battery using the plastic opening tool. The tape can be found in the middle and either side of the battery.

Carefully break the bond between the inner tape and the battery using the plastic opening tool. The tape can be found in the middle and either side of the battery.

Step 9

  • Remove battery pack

Remove battery pack

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 4 other contributors 


                    Adam Fierce

Member since: 09/15/2016

418 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team 18-4, Blackwell Fall 2016                        

                                                  Member of USF Tampa, Team 18-4, Blackwell Fall 2016 



                    USFT-BLACKWELL-F16S18G4                     


                                            4 Members                     


                                            6 Guides authored

alibar1 - Mar 8, 2018

Reply

Good show .i like the simple steps