Difficulty
Easy
Steps
4
Time Required
3 minutes
Sections
1
- RAM
- 4 steps
Flags
0
BackAcer Nitro 5 AN515-53-55G9
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
RAM
- Make sure laptop is off and unplugged before beginning replacement.
- Flip the laptop upside down so the bottom is facing up.
- Identify the RAM tray on the bottom of the laptop.
Make sure laptop is off and unplugged before beginning replacement.
Flip the laptop upside down so the bottom is facing up.
Identify the RAM tray on the bottom of the laptop.
1024
Step 2
- Use the Phillips #0 screwdriver to remove the 9mm screw in the bottom left corner of the RAM tray covering.
- Remove the RAM tray cover by prying up with a spudger.
Use the Phillips #0 screwdriver to remove the 9mm screw in the bottom left corner of the RAM tray covering.
Remove the RAM tray cover by prying up with a spudger.
Step 3
- Locate the silver clips holding the RAM tray.
- Push the silver pins holding the RAM tray down away from RAM. Slight pressure may be required. The RAM tray should pop up at an angle.
Locate the silver clips holding the RAM tray.
Push the silver pins holding the RAM tray down away from RAM. Slight pressure may be required. The RAM tray should pop up at an angle.
Step 4
- Slide ram card out of its groove.
- When installing the new RAM card, make sure to slide the card in at the correct orientation.
- The gold pins should be on the bottom and you must line up the pin slot guide.
Slide ram card out of its groove.
When installing the new RAM card, make sure to slide the card in at the correct orientation.
The gold pins should be on the bottom and you must line up the pin slot guide.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Rheo Bruer
Member since: 02/05/2019
931 Reputation
4 Guides authored
Badges:
15
+12 more badges
Team
Appalachian State University, Team S2-G2, Menagarishvili Spring 2019
Member of Appalachian State University, Team S2-G2, Menagarishvili Spring 2019
APSU-MENAGARISHVILI-S19S2G2
3 Members
9 Guides authored
The 300lb Gorilla - Aug 23, 2019
Reply
NOTE: Just FYI, once you have added another ram module to this laptop, and you turn it on, the screen may stay blank for up to a minute while the BIOS registers the new memory. Don’t panic if your screen does not come on right away. Give the BIOS time to update the new memory.
When I updated the ram in my Acer Nitro 5, the screen did not come on right away, and I thought it was a non compatible ram module, but this was not the case, just had to be patient.
Casey O’Brien - Sep 16, 2019
Reply
Can you take ram out of an aspire e15 and put in a nitro and have it work?
william - Jun 2, 2021
Reply
I have a nitro 5, but it does not have the ram thing on the bottom of it. does the change what it looks like inside?
Rheo Bruer - Jun 2, 2021
This guide refers to the 53-generation Nitro 5 (AN515-53) but I believe you are referring to the 54-generation (AN515-54). While they do not look exactly the same under the cover, they are very similar and the hardware is close to the same place and the RAM is installed using the same process.
william - Jun 2, 2021
ok thank you so much.so instead of the small cover I just take the bottom panel off.