Difficulty

Easy

Steps

6

Time Required

                          10 - 15 minutes

Sections

2

  • Back Panel
  • 2 steps
  • Battery
  • 4 steps

Flags

0

  • BackAcer One 10 S1003-19GY

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Power off the device and make sure it is disconnected from any external devices.
  • Use a plastic opening tool to create a gap between the front and back casing of the device.
  • Slowly maneuver the plastic tool around the entire perimeter of the tablet to separate the front and back.

Power off the device and make sure it is disconnected from any external devices.

Use a plastic opening tool to create a gap between the front and back casing of the device.

Slowly maneuver the plastic tool around the entire perimeter of the tablet to separate the front and back.

1024

Step 2

  • Set the device screen side down and remove the back casing.

Set the device screen side down and remove the back casing.

Step 3

              Battery
  • Remove the two pieces of transparent yellow tape inside the device.
  • Using the Phillips #0 screwdriver, remove the two screws on either side of the connector.
  • Grab the the connector with tweezers and pull it slightly away from the motherboard.

Remove the two pieces of transparent yellow tape inside the device.

Using the Phillips #0 screwdriver, remove the two screws on either side of the connector.

Grab the the connector with tweezers and pull it slightly away from the motherboard.

Step 4

  • Flip the small black latch up on the connector where the ribbon inserts.
  • Gently pull the ribbon out of the connection.
  • Repeat this process on the upper orange ribbon connection.

Flip the small black latch up on the connector where the ribbon inserts.

Gently pull the ribbon out of the connection.

Repeat this process on the upper orange ribbon connection.

Step 5

  • Peel back the black tape holding the battery in the three corners of the battery.

Peel back the black tape holding the battery in the three corners of the battery.

Step 6

  • Carefully pry the battery off of the adhesive on one side with a plastic spudger.
  • Remove the battery from the device.
  • We recommend to NOT use a metal spudger for this guide as a metal spudger can easily puncture lithium-ion batteries and cause further damage to yourself and the device.

Carefully pry the battery off of the adhesive on one side with a plastic spudger.

Remove the battery from the device.

We recommend to NOT use a metal spudger for this guide as a metal spudger can easily puncture lithium-ion batteries and cause further damage to yourself and the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Trey Wintzinger

Member since: 09/04/2018

605 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       University of Alabama, Team S2-G8, Bedsole Fall 2018                        

                                                  Member of University of Alabama, Team S2-G8, Bedsole Fall 2018 



                    UA-BEDSOLE-F18S2G8                     


                                            4 Members                     


                                            6 Guides authored

Nico V - Sep 11, 2022

Reply

Does anyone know where I can get a replacement battery and ship it to EU? Sadly, this Laptop doesnt turn on without the battery.