Difficulty

Moderate

Steps

6

Time Required

                          15 - 25 minutes

Sections

2

  • Back Panel
  • 2 steps
  • Front/Rear Camera
  • 4 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackAcer One 10 S1003-19GY

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Power off the device and make sure it is disconnected from any external devices.
  • Use a plastic opening tool to create a gap between the front and back casing of the device.
  • Slowly maneuver the plastic tool around the entire perimeter of the tablet to separate the front and back.

Power off the device and make sure it is disconnected from any external devices.

Use a plastic opening tool to create a gap between the front and back casing of the device.

Slowly maneuver the plastic tool around the entire perimeter of the tablet to separate the front and back.

1024

Step 2

  • Set the device screen side down and remove the back casing.

Set the device screen side down and remove the back casing.

Step 3

              Front/Rear Camera
  • Locate the Rear Camera in the upper right hand corner of the motherboard.

Locate the Rear Camera in the upper right hand corner of the motherboard.

Step 4

  • Using a relatively thin flat head screwdriver, pry the camera connection from the motherboard.
  • The connection should remove easily as it just snaps to the motherboard.

Using a relatively thin flat head screwdriver, pry the camera connection from the motherboard.

The connection should remove easily as it just snaps to the motherboard.

Step 5

  • Remove the five screws on the outer edge of the motherboard using a Phillips #0 screwdriver.

Remove the five screws on the outer edge of the motherboard using a Phillips #0 screwdriver.

Step 6

  • Open the black flap on the connection and gently pull the ribbon from it.
  • Slightly raise the motherboard from the upper side to remove the camera as shown.

Open the black flap on the connection and gently pull the ribbon from it.

Slightly raise the motherboard from the upper side to remove the camera as shown.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Trey Wintzinger

Member since: 09/04/2018

605 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       University of Alabama, Team S2-G8, Bedsole Fall 2018                        

                                                  Member of University of Alabama, Team S2-G8, Bedsole Fall 2018 



                    UA-BEDSOLE-F18S2G8                     


                                            4 Members                     


                                            6 Guides authored