Difficulty
Easy
Steps
3
Time Required
9 - 10 minutes
Sections
2
- Back Panel
- 2 steps
- WiFi Antenna
- 1 step
Flags
0
BackAcer One 10 S1003-19GY
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Power off the device and make sure it is disconnected from any external devices.
- Use a plastic opening tool to create a gap between the front and back casing of the device.
- Slowly maneuver the plastic tool around the entire perimeter of the tablet to separate the front and back.
Power off the device and make sure it is disconnected from any external devices.
Use a plastic opening tool to create a gap between the front and back casing of the device.
Slowly maneuver the plastic tool around the entire perimeter of the tablet to separate the front and back.
1024
Step 2
- Set the device screen side down and remove the back casing.
Set the device screen side down and remove the back casing.
Step 3
WiFi Antenna
- Disconnect the black ribbon connection attached to the motherboard.
- Remove the chip fully by pulling the plastic tab on the left out.
Disconnect the black ribbon connection attached to the motherboard.
Remove the chip fully by pulling the plastic tab on the left out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Trey Wintzinger
Member since: 09/04/2018
605 Reputation
5 Guides authored
Badges:
9
+6 more badges
Team
University of Alabama, Team S2-G8, Bedsole Fall 2018
Member of University of Alabama, Team S2-G8, Bedsole Fall 2018
UA-BEDSOLE-F18S2G8
4 Members
6 Guides authored
