Acer Spin 3 Sp315 51 757C Speaker Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          10 - 25 minutes

Sections

Back Panel
3 steps
Speaker
5 steps

Flags

BackAcer Spin 3 SP315-51-757C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Remove eleven Phillips #0 screws from the back panel.

Remove eleven Phillips #0 screws from the back panel.

1024

Step 2

Using an opening tool, pry open the back panel, starting at the silver screen hinges.
You may need to apply more force than usual. If you don’t find any success at the hinges, you can try to start at another area that looks easier to open.
You can also use some plastic opening picks to help hold parts of the panel open while you work on other sides.

Using an opening tool, pry open the back panel, starting at the silver screen hinges.

You may need to apply more force than usual. If you don’t find any success at the hinges, you can try to start at another area that looks easier to open.

You can also use some plastic opening picks to help hold parts of the panel open while you work on other sides.

Step 3

Lift the back panel off of the laptop.

Lift the back panel off of the laptop.

Step 4

              Speaker

Using either your nails or a pair of small tweezers, remove the speaker’s motherboard cable.

Using either your nails or a pair of small tweezers, remove the speaker’s motherboard cable.

Step 5

Remove the Phillips #0 screws from each speaker.
After unscrewing the right-side speaker, you will notice that its corner is used to secure a couple cables. You will need to remove these in order to remove the speaker.

Remove the Phillips #0 screws from each speaker.

After unscrewing the right-side speaker, you will notice that its corner is used to secure a couple cables. You will need to remove these in order to remove the speaker.

Step 6

Remove the Phillips #0 screws holding down the laptop’s fan.

Remove the Phillips #0 screws holding down the laptop’s fan.

Step 7

Lift up the fan as lightly as possible to remove the speaker’s wires underneath.
Be careful not to bend the copper conduction rod too much. A small bend is okay as long as there are no breaks in the rod.

Lift up the fan as lightly as possible to remove the speaker’s wires underneath.

Be careful not to bend the copper conduction rod too much. A small bend is okay as long as there are no breaks in the rod.

Step 8

Carefully maneuver the wires from under the fan and remove each speaker from the case.

Carefully maneuver the wires from under the fan and remove each speaker from the case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Skyler Ognibene

Member since: 09/17/2019

898 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Embry-Riddle Aeronautical University, Team S20-G2, Branham Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S20-G2, Branham Fall 2019 



                    ERAU-BRANHAM-F19S20G2                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team