Difficulty

Moderate

Steps

7

Time Required

                          25 - 40 minutes

Sections

3

  • Back Panel
  • 2 steps
  • Screen Assembly
  • 2 steps
  • Touch Screen
  • 3 steps

Flags

4

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackAcer Spin 3 SP315-51-79NT

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Using the Phillips #1 screwdriver, remove twelve (12) screws from the back panel.

Using the Phillips #1 screwdriver, remove twelve (12) screws from the back panel.

1024

Step 2

  • Gently pry the back plate off with your fingers.

Gently pry the back plate off with your fingers.

Step 3

              Screen Assembly
  • Using the Phillips #1 screwdriver, remove a total of four screws from the hinges (two on each hinge).

Using the Phillips #1 screwdriver, remove a total of four screws from the hinges (two on each hinge).

Step 4

  • Remove wires connecting to motherboard.
  • You can then simply pull the two halves of the computer away from each other.

Remove wires connecting to motherboard.

You can then simply pull the two halves of the computer away from each other.

Step 5

              Touch Screen
  • Use a spudger to separate the plastic cover from the screen assembly.
  • Do not use a metal spudger for this step. The metal spudger should only be used for serious prying power. When used incorrectly, the metal spudger can cause serious damage to the internal components (especially glass) in the device.

Use a spudger to separate the plastic cover from the screen assembly.

Do not use a metal spudger for this step. The metal spudger should only be used for serious prying power. When used incorrectly, the metal spudger can cause serious damage to the internal components (especially glass) in the device.

Step 6

  • Using the Phillips #1 screwdriver, remove the four screws securing the touch screen to the rest of the assembly.

Using the Phillips #1 screwdriver, remove the four screws securing the touch screen to the rest of the assembly.

Step 7

  • Flip over the touch screen to reveal the circuit board.
  • Disconnect the cable from the circuit board and completely remove the touch screen from the device.

Flip over the touch screen to reveal the circuit board.

Disconnect the cable from the circuit board and completely remove the touch screen from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors 


                    Nolan Martinous

Member since: 10/25/2021

324 Reputation

                                      2 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 2-1, Sinclaire Fall 2021                        

                                                  Member of UMass Dartmouth, Team 2-1, Sinclaire Fall 2021 



                    UMASSD-SINCLAIRE-F21S2G1                     


                                            3 Members                     


                                            6 Guides authored