Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes

Sections

2

  • Stand
  • 1 step
  • Back Cover
  • 5 steps

Flags

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackAcer X191 monitor

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Stand
  • Lay the monitor on a flat surface, facedown.
  • Use a #1 Phillips screwdriver to remove the 4x 10.2mm screws securing the stand to the back panel.
  • Remove the stand from the back panel by pulling it up.

Lay the monitor on a flat surface, facedown.

Use a #1 Phillips screwdriver to remove the 4x 10.2mm screws securing the stand to the back panel.

Remove the stand from the back panel by pulling it up.

1024

Step 2

              Back Cover
  • Remove the 2x 9.8mm Phillips #1 screws securing the back cover to the monitor.

Remove the 2x 9.8mm Phillips #1 screws securing the back cover to the monitor.

Step 3

  • Work your way around the monitor, putting the flathead screwdriver into the space between the front and back covers, and prying up.
  • Twisting the screwdriver can help, but you can easily mess up the plastic without getting anything out of it by doing so. Be cautious.
  • Ideally you want to pry at the locations that have the little gaps, which are locking mechanisms.
  • You should hear a poping sound and the back cover should lift a little if you are prying at the right locations.

Work your way around the monitor, putting the flathead screwdriver into the space between the front and back covers, and prying up.

Twisting the screwdriver can help, but you can easily mess up the plastic without getting anything out of it by doing so. Be cautious.

Ideally you want to pry at the locations that have the little gaps, which are locking mechanisms.

You should hear a poping sound and the back cover should lift a little if you are prying at the right locations.

Step 4

  • I’ve highlighted the locations of the locking mechanisms for the back cover, try prying in these locations for the best results.
  • Right side of the monitor.
  • Top of the monitor.
  • Left side of the monitor.

I’ve highlighted the locations of the locking mechanisms for the back cover, try prying in these locations for the best results.

Right side of the monitor.

Top of the monitor.

Left side of the monitor.

Step 5

  • On the bottom side, be careful not to pry on the monitor buttons.
  • Bottom of the monitor locking mechanism locations.

On the bottom side, be careful not to pry on the monitor buttons.

Bottom of the monitor locking mechanism locations.

Step 6

  • The monitor back cover will then pull right off.

The monitor back cover will then pull right off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Sam

Member since: 09/13/2014

890 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges