Difficulty

Moderate

Steps

9

Time Required

                          5 minutes

Sections

3

  • Handset
  • 1 step
  • Lower Case
  • 5 steps
  • Motherboard
  • 3 steps

Flags

0

  • BackACN Iris WG4K

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Handset
  • Press upwards with your index finger on the 4P4C connector as shown in the image.
  • Pull the connector gently out of its socket.

Press upwards with your index finger on the 4P4C connector as shown in the image.

Pull the connector gently out of its socket.

1024

Step 2

              Lower Case
  • Flip the main body of the video phone so that the bottom is facing up.
  • Use the Phillips #0 Screwdriver to remove the four Phillips head screws (6 mm) highlighted by the red circles.

Flip the main body of the video phone so that the bottom is facing up.

Use the Phillips #0 Screwdriver to remove the four Phillips head screws (6 mm) highlighted by the red circles.

Step 3

  • Lift the back case upwards to expose the inside components.
  • Red rectangles indicate the three ribbon cables.
  • The orange square indicates the blade connector.

Lift the back case upwards to expose the inside components.

Red rectangles indicate the three ribbon cables.

The orange square indicates the blade connector.

Step 4

  • Disconnect the three ribbon cables from their insulation-displacement connectors by flipping up the black plastic clip.
  • Gently pull the ribbon cables out of their insulation-displacement connectors.

Disconnect the three ribbon cables from their insulation-displacement connectors by flipping up the black plastic clip.

Gently pull the ribbon cables out of their insulation-displacement connectors.

Step 5

  • Disconnect the blade connector from the blade receptacle by gripping the exposed area of the blade connector.
  • Gently pull the blade connector out of the blade receptacle.

Disconnect the blade connector from the blade receptacle by gripping the exposed area of the blade connector.

Gently pull the blade connector out of the blade receptacle.

Step 6

  • Gently lift up the lower case to separate it from the top case.

Gently lift up the lower case to separate it from the top case.

Step 7

              Motherboard
  • Use the Phillips #0 Screwdriver to remove the four Phillips head screws (6 mm) highlighted by the red circles.

Step 8

  • Firmly grasp the black port wall.
  • Pull up and push out to remove it from the lower case.

Firmly grasp the black port wall.

Pull up and push out to remove it from the lower case.

Step 9

  • Gently lift the motherboard out of the lower case.

Gently lift the motherboard out of the lower case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Itze Kenney

Member since: 02/14/2017

1,066 Reputation

                                      9 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team 20-4, Remmell Spring 2017                        

                                                  Member of USF Tampa, Team 20-4, Remmell Spring 2017 



                    USFT-REMMELL-S17S20G4                     


                                            4 Members                     


                                            20 Guides authored