Acurite 02032 Wind Cup Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

3

• Battery
• 3 steps
• Base
• 2 steps
• Wind Cup Assembly
• 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackAcuRite 02032

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Battery               

• Remove the battery compartment lid by lifting upward.

Remove the battery compartment lid by lifting upward.

1024

Step 2

• Pull the ribbon to eject the 2 X AA alkaline batteries.

Pull the ribbon to eject the 2 X AA alkaline batteries.

Step 3

• Once the batteries are removed, it is safe to proceed.

Once the batteries are removed, it is safe to proceed.

Step 4

              Base               

• Remove the four 0.8cm screws that attach the bottom panel to the device
• An extended driver is needed to reach 3 of these screws. If you are using the 64 - bit driver kit you can extend the driver by inserting the driver PH1, (Phillips size 1) into the size 4 hexagonal adapter.

Remove the four 0.8cm screws that attach the bottom panel to the device

An extended driver is needed to reach 3 of these screws. If you are using the 64 - bit driver kit you can extend the driver by inserting the driver PH1, (Phillips size 1) into the size 4 hexagonal adapter.

Step 5

• Gently lift the top section of the weather center away from the base. With all the screws removed it should lift off easily.

Gently lift the top section of the weather center away from the base. With all the screws removed it should lift off easily.

Step 6

              Wind Cup Assembly               

• Remove the four 0.8cm screws inside the case located near the fan using the J1 screw bit.

Remove the four 0.8cm screws inside the case located near the fan using the J1 screw bit.

Step 7

• With all four screws removed, the wind cup assembly should lift straight up off the middle section.
• Set down the bottom half of the weather center careful. There are two small pegs that will break with the slightest amount of pressure.

With all four screws removed, the wind cup assembly should lift straight up off the middle section.

Set down the bottom half of the weather center careful. There are two small pegs that will break with the slightest amount of pressure.

Step 8

• Replace the old wind cup assembly with the new assembly that was purchased.

Replace the old wind cup assembly with the new assembly that was purchased.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Ben Kegel                     

Member since: 09/15/2016

350 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       CSU Fullerton, Team 1-4, Bruce Fall 2016                        

                                                  Member of CSU Fullerton, Team 1-4, Bruce Fall 2016 



                    CSUF-BRUCE-F16S1G4                     


                                            5 Members                     


                                            7 Guides authored                     

Tom Halverson - May 11, 2018

Reply

Do you have to replace the whole top, wind cups,top plate with solar panel, just for the wind cups?

For a broken wind cups do you have to replace the top section with the solar panel?