Difficulty

Moderate

Steps

3

Time Required

Suggest a time??

Sections

1

  • Adding a Power Fuse to U2C on Troodon with Can Bus
  • 3 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackTroodon Add A U2C Fuse

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Step 1

              Prepair For install
  • Shut down printer and unplug the power cable from the printer
  • Loosen the front panel screws, then remove the front cover panel and set the cover down in front of the machine.
  • Note, you will need about 6-8 inches of space in front of the machine to set the front cover panel down on, so you can work on the machine
  • Locate the power cable coming from the power supply.
  • Pull it forward slowly
  • Give your self about 6-8 inches of cable from the U2C power terminal and cut the power cable

Shut down printer and unplug the power cable from the printer

Loosen the front panel screws, then remove the front cover panel and set the cover down in front of the machine.

Note, you will need about 6-8 inches of space in front of the machine to set the front cover panel down on, so you can work on the machine

Locate the power cable coming from the power supply.

Pull it forward slowly

Give your self about 6-8 inches of cable from the U2C power terminal and cut the power cable

1024

Step 2

              Prepair the wire
  • Once the cable is cut, strip both ends of the wire back 8-10 mm.

Once the cable is cut, strip both ends of the wire back 8-10 mm.

Step 3

  • The wire is going connect to go into the Wago connector then through the fuse and back to the U2C
  • The fuse holder/ Wago is non - directional, so it does not matter which side is in out. Either way will pass the power wire through the fuse correctly.
  • Lift up the orange lever on an open terminal and insert one stripped end as far into the hole as possible then snap the lever closed. Repeat for the other side.

The wire is going connect to go into the Wago connector then through the fuse and back to the U2C

The fuse holder/ Wago is non - directional, so it does not matter which side is in out. Either way will pass the power wire through the fuse correctly.

Lift up the orange lever on an open terminal and insert one stripped end as far into the hole as possible then snap the lever closed. Repeat for the other side.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    AJ Pereira

Member since: 05/29/2020

2,049 Reputation

                                      14 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Tiny Machines 3D                        

                                                  Member of Tiny Machines 3D 



                    Community                     


                                            5 Members                     


                                            31 Guides authored