Adjusting The Bowl Height Repair Guide

Difficulty

Moderate

Steps

3

Time Required

                          20 minutes            

Sections

1

• Adjusting the bowl height
• 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackHobart N50

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Adjusting the bowl height               

• Safety first! - Unplug the mixer, the first rule in any electronic repair.
• Prepare a cloth and turn the unit upside down making sure it is secure and that it is not being scratched.

Safety first! - Unplug the mixer, the first rule in any electronic repair.

Prepare a cloth and turn the unit upside down making sure it is secure and that it is not being scratched.

1024

Step 2

• With the unit upside down unscrew the four indicated screws using a fairly large Phillips Screwdriver
• Secure the base with one hand while removing the last screw as it may fall.
• After removing the screws remove the base and place it in a safe place. Beware that it may be dirty/oily in the uncovered area. Clean as necessary.
• The 4 screws that need to be removed

With the unit upside down unscrew the four indicated screws using a fairly large Phillips Screwdriver

Secure the base with one hand while removing the last screw as it may fall.

After removing the screws remove the base and place it in a safe place. Beware that it may be dirty/oily in the uncovered area. Clean as necessary.

The 4 screws that need to be removed

Step 3

• The removal of the base gives access to the adjusting screw.
• Tightening will raise the bowl position, loosening the screw will lower the bowl position.
• The 11mm screw that needs to be adjusted.

The removal of the base gives access to the adjusting screw.

Tightening will raise the bowl position, loosening the screw will lower the bowl position.

The 11mm screw that needs to be adjusted.

To reassemble your device, follow these instructions in reverse order making sure that before tightening the Phillips screws the base is aligned as it was before to prevent any visible lines where paint may be missing/damaged that were previously covered by the alignment of the base.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Dan Mihai Ile                     

Member since: 10/16/2012

186 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Faisal Mohamed - Mar 2, 2020

Reply

i need fix my mix dough