Difficulty

Moderate

Steps

10

Time Required

Suggest a time??

Sections

2

  • Head
  • 3 steps
  • Axle and Handle
  • 7 steps

Flags

0

  • BackAfridev

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Head
  • Assemble the required tools, including the Afridev tool and crescent wrenches.

Assemble the required tools, including the Afridev tool and crescent wrenches.

1024

Step 2

  • Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

Perform a water test on the pump, by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

Step 3

  • Loosen the bolt on front of the face plate with the Afridev tool.
  • Remove the plate from the pump by lifting it straight up.

Loosen the bolt on front of the face plate with the Afridev tool.

Remove the plate from the pump by lifting it straight up.

Step 4

              Axle and Handle
  • Insert the T-handle into the top cylinder of the exposed pump rod.

Insert the T-handle into the top cylinder of the exposed pump rod.

Step 5

  • Loosen the 2 bolts on either side of handle.
  • It is not necessary to remove the bolt at this time; however, take caution to not let the bolt fall out of the handle.

Loosen the 2 bolts on either side of handle.

It is not necessary to remove the bolt at this time; however, take caution to not let the bolt fall out of the handle.

Step 6

  • Loosen the 2 bolts on either side of the head to remove the handle from the pump rod.
  • It is not necessary to remove the bolt at this time; however, take caution to not let the bolt fall out of the handle.

Loosen the 2 bolts on either side of the head to remove the handle from the pump rod.

Step 7

  • Lift the handle to a horizontal position.

Lift the handle to a horizontal position.

Step 8

  • While one person lifts up on the T-handle, remove the bolt and connection pieces.

While one person lifts up on the T-handle, remove the bolt and connection pieces.

Step 9

  • Remove the bolt and connection pieces from the handle.
  • Set the bolt pieces in a sanitary place, such as a bucket, to prevent contamination.

Remove the bolt and connection pieces from the handle.

Set the bolt pieces in a sanitary place, such as a bucket, to prevent contamination.

Step 10

  • Remove the handle from the pump.
  • Be sure to set the handle in a sanitary place to prevent contamination.

Remove the handle from the pump.

Be sure to set the handle in a sanitary place to prevent contamination.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Jake Devincenzi

Member since: 04/18/2011

116,089 Reputation

                                      57 Guides authored                  



                       Badges:
                       51







                                                        +48 more badges