Difficulty
Difficult
Steps
3
Time Required
20 minutes
Sections
2
- Back Cover
- 1 step
- Battery
- 2 steps
Flags
0
BackAfterglow Wireless PS3 Controller
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Lay the controller face down on a flat surface and remove the seven 9mm Phillips #0 screws on the back of the controller.
- Lift up and remove the controller back plate.
Lay the controller face down on a flat surface and remove the seven 9mm Phillips #0 screws on the back of the controller.
Lift up and remove the controller back plate.
1024
Step 2
Battery
- Carefully remove the battery by lifting it straight up from its place.
- Keep in mind that the red and black battery wires are attached to the motherboard. Handle these with care.
Carefully remove the battery by lifting it straight up from its place.
Keep in mind that the red and black battery wires are attached to the motherboard. Handle these with care.
Step 3
- Use the soldering tool to heat the solder connecting the battery wires to the motherboard.
- The soldering gun will loosen the bonds of the solder allowing the wires to be detached. Use this guide for further details on how to solder.
Use the soldering tool to heat the solder connecting the battery wires to the motherboard.
The soldering gun will loosen the bonds of the solder allowing the wires to be detached. Use this guide for further details on how to solder.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Aj Coello
Member since: 02/17/2017
693 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team S19-G5, Hoffman Spring 2017
Member of USF Tampa, Team S19-G5, Hoffman Spring 2017
USFT-HOFFMAN-S17S19G5
4 Members
14 Guides authored