Difficulty

Moderate

Steps

8

Time Required

                          15 minutes

Sections

1

  • Plunger
  • 8 steps

Flags

3

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

  • BackAir Blasters Tek Six

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove screws of the grey slider
  • Using a screwdriver, remove the two 11.6 mm phillips 00 screws holding the grey slider together.
  • Remove grey slider from the main body of the blaster.

Using a screwdriver, remove the two 11.6 mm phillips 00 screws holding the grey slider together.

Remove grey slider from the main body of the blaster.

1024

Step 2

              Remove screws in main  body
  • Using a screwdriver, remove the six 9 mm phillips 00 screws holding the main body together.

Using a screwdriver, remove the six 9 mm phillips 00 screws holding the main body together.

Step 3

              Take the main body apart
  • Using the plastic opening tools, carefully take apart the main case of the blaster to leave the inside exposed.

Using the plastic opening tools, carefully take apart the main case of the blaster to leave the inside exposed.

Step 4

              Remove screw holding the bottom spring to the air system
  • Using a screwdriver, remove the 7.5 mm phillips 00 screw holding the bottom spring to the air system.

Using a screwdriver, remove the 7.5 mm phillips 00 screw holding the bottom spring to the air system.

Step 5

              Remove metal pin
  • Carefully grab the metal pin keeping the air system and top spring stationary, and slide it outwards. This will release the air system with the plunger completely.

Carefully grab the metal pin keeping the air system and top spring stationary, and slide it outwards. This will release the air system with the plunger completely.

Step 6

              Remove air system screw
  • Using a screwdriver, remove the 5.2 mm phillips 00 screw holding the air system to the body of the blaster.

Using a screwdriver, remove the 5.2 mm phillips 00 screw holding the air system to the body of the blaster.

Step 7

              Take the air system out
  • Grab the whole air system and carefully take it out of the main body of the blaster.

Grab the whole air system and carefully take it out of the main body of the blaster.

Step 8

              Remove plunger
  • Now, grab the gray plunger with your hand and slide it outwards to remove it.

Now, grab the gray plunger with your hand and slide it outwards to remove it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 5 other contributors 


                    Alfredo Antolinez

Member since: 09/22/2014

347 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team 3-1, Brown Fall 2014                        

                                                  Member of USF Tampa, Team 3-1, Brown Fall 2014 



                    USFT-BROWN-F14S3G1                     


                                            3 Members                     


                                            5 Guides authored