Air Hog Smash Bots Radio Receiver Replacement Repair Guide

Difficulty

Moderate

Steps

10

Time Required

                          10 minutes            

Sections

3

• Batteries
• 3 steps
• External Casing
• 5 steps
• Radio Receiver
• 2 steps

Flags

1

Featured Student Guide

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

• BackAir Hog Smash Bots

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Batteries               

• Using the Phillips #0 screwdriver to remove the 8 mm screw.

Using the Phillips #0 screwdriver to remove the 8 mm screw.

1024

Step 2

• Lift and slide the batter cover away from the tab holding it in place at the bottom.

Lift and slide the batter cover away from the tab holding it in place at the bottom.

Step 3

• Remove the 3 AAA batteries.

Remove the 3 AAA batteries.

Step 4

              External Casing               

• Using a Phillip #0 screwdriver to remove the eight 8 mm screws.

Using a Phillip #0 screwdriver to remove the eight 8 mm screws.

Step 5

• Remove the upper armor of the Smash Bot.

Remove the upper armor of the Smash Bot.

Step 6

• Hold the upper body and slide out the bottom half of the Smash Bot.
• The motor extends from the lower-body into the upper-body. Be careful to not damage the motor.

Hold the upper body and slide out the bottom half of the Smash Bot.

The motor extends from the lower-body into the upper-body. Be careful to not damage the motor.

Step 7

• Peel back the four decal stickers that hold the front and back of the bot together.

Peel back the four decal stickers that hold the front and back of the bot together.

Step 8

• Use the plastic opening tool to pry the front and back of the lower body apart.
• Carefully remove the back of the bot from the front.

Use the plastic opening tool to pry the front and back of the lower body apart.

Carefully remove the back of the bot from the front.

Step 9

              Radio Receiver               

• Use the Phillips 0 screwdriver to remove two 4.75mm screws.

Use the Phillips 0 screwdriver to remove two 4.75mm screws.

Step 10

• Use the soldering workstation to remove the five wires. Directions on how to solder can be found here.

Use the soldering workstation to remove the five wires. Directions on how to solder can be found here.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Brittany Frecker                     

Member since: 02/08/2016

542 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       IUPUI, Team 1-1, Baechle Spring 2016                        

                                                  Member of IUPUI, Team 1-1, Baechle Spring 2016 



                    IUPUI-BAECHLE-S16S1G1                     


                                            4 Members                     


                                            7 Guides authored