Difficulty
Moderate
Steps
11
Time Required
10 minutes
Sections
2
- How to Properly Clean the Airox Legendair
- 5 steps
- Battery
- 6 steps
Flags
0
BackAirox Legendair Ventilator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The repair guide information is mentioned in following sections of the user repair manual as well:
· Chapter 2 – 2.1.1 Cleaning the Device
· Chapter 2 – 2.4.1 Opening and Closing
· Chapter 5 – 5.1.1 Removal/Installation of the Battery
What you need
Step 1
How to Properly Clean the Airox Legendair
- First, switch off the device.
First, switch off the device.
1024
Step 2
- Place the device in a clean and open environment.
Place the device in a clean and open environment.
Step 3
- Using a cloth or a sponge slightly dampened with a bactericide or germicide solution, gently clean the outside of the device.
Using a cloth or a sponge slightly dampened with a bactericide or germicide solution, gently clean the outside of the device.
Step 4
- If necessary, spray the device lightly with the germicide solution, taking account of the requirements discussed in the preliminary operations.
- Do not allow any liquid to enter inside the device (in particular through the cooling apertures).
If necessary, spray the device lightly with the germicide solution, taking account of the requirements discussed in the preliminary operations.
Do not allow any liquid to enter inside the device (in particular through the cooling apertures).
Step 5
- Use a gentle air blast to clear away any remaining liquid from ventilator.
Use a gentle air blast to clear away any remaining liquid from ventilator.
Step 6
Battery
- Make sure to turn off the ventilator before starting the repair.
- Before you start the battery replacement process, make sure that the device has been placed in a clean and open environment.
Make sure to turn off the ventilator before starting the repair.
Before you start the battery replacement process, make sure that the device has been placed in a clean and open environment.
Step 7
- Remove each attachment screw from the battery cover.
Remove each attachment screw from the battery cover.
Step 8
- Remove the battery cover carefully by holding the rails and pulling toward the rear of the device.
Remove the battery cover carefully by holding the rails and pulling toward the rear of the device.
Step 9
- Extract the current battery and replace it with the new battery.
Extract the current battery and replace it with the new battery.
Step 10
- Confirm that all elements line up together. Then, reattach the battery cover with the attachment screws that were removed in Step 2.
Confirm that all elements line up together. Then, reattach the battery cover with the attachment screws that were removed in Step 2.
Step 11
- Switch the device to “Set Up Mode” by pressing the On/Off switch.
- Hold the menu key until the menu options appear on the screen.
- Select the “MAINTENANCE” option with cursor.
- Select “Voltage control” and verify that the voltage of the battery is 28.5±1V.
Switch the device to “Set Up Mode” by pressing the On/Off switch.
Hold the menu key until the menu options appear on the screen.
Select the “MAINTENANCE” option with cursor.
Select “Voltage control” and verify that the voltage of the battery is 28.5±1V.
Perform the final inspection procedures by confirming that every screw is secure before putting back into service.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Caleb Erlenborn
Member since: 04/09/2020
174 Reputation
1 Guide authored
Badges:
3
Team
Cal Poly, Team S7-G15, Paton Spring 2020
Member of Cal Poly, Team S7-G15, Paton Spring 2020
CPSU-PATON-S20S7G15
3 Members
4 Guides authored
