Difficulty
Easy
Steps
3
Time Required
15 - 20 minutes
Sections
1
- Oil
- 3 steps
Flags
Grammar Police
Embrace your inner English teacher and help improve this guide’s grammar!
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackAirpress LM 50-350
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The system takes about 0.2 liter (6.5 oz) of compressor oil.
What you need
Step 1
prepare draining oil
- To ease the draining process, run the compressor for a few minutes and warm up the oil a bit.
- Make sure to unplug the compressor at this point.
- Unscrew the filler cap to allow air into the reservoir.
To ease the draining process, run the compressor for a few minutes and warm up the oil a bit.
Make sure to unplug the compressor at this point.
Unscrew the filler cap to allow air into the reservoir.
1024
Step 2
drain the oil
- Using the 5mm hex key, unscrew the drainage plug.
- With the plug removed, let the reservoir drain until no more oil comes out.
Using the 5mm hex key, unscrew the drainage plug.
With the plug removed, let the reservoir drain until no more oil comes out.
Step 3
add oil
- Screw the drainage plug back on.
- Add the new oil through the filler hole.
- Make sure the oil level on the indicator is between the lines.
Screw the drainage plug back on.
Add the new oil through the filler hole.
Make sure the oil level on the indicator is between the lines.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
knipwim
Member since: 09/01/2018
7,452 Reputation
29 Guides authored
Badges:
37
+34 more badges